How to patch a hole in drywall: materials, tools, tips, repair

Date:

2018-03-27 20:51:13

Views:

480

Rating:

1Like 0Dislike

Share:

Table of contents:

In modern construction and repair work drywall is a very popular material. With his help, made the interior walls, align walls, ceilings, and also create elegant decorative elements for interior decoration. With its simplicity and versatility, this material has one major drawback-susceptibility to mechanical damage. Heavy blows, careless moving furniture and even the active children's games can cause undesirable defects on the surface of the wall. In this regard, the question of how to fix a hole in drywall, is relevant today for many homeowners, so in this article we will pay special attention.

Preparing

Upon detection of such a flaw in the wall or in the ceiling should not panic, because this situation is fixable and will not require the owners of large financial costs. Restoration of such structures-an easy enough process that you can do yourself with simple materials.how to patch a hole in drywall

Before beginning work to clean out the hole in the drywall-to remove hanging pieces of paper and remove weak and deformed holding elements. Next you need to determine the dimensions of the damaged area. Measurements should be carried out with all the cracks, chips and scratches. If the section of the wall failed as a result of flooding water, all wet parts of the sheet should be replaced. Focusing on the extent of damage, determine how to patch the hole in the drywall in a particular case.

Recommended

The most effective methods of seed germination

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

Basic methods of repair

Depending on the size of the hole is chosen method to eliminate any flaw. Repair damaged wall can be done in the following ways:

  • Using a spatula and reinforcement tape;
  • Method of creating patches;
  • Applying the patch with the preliminary arrangement of the crates.

Small cracks in drywall and up to a diameter of 50 mm are eliminated by the first method. In this case, the damaged section is glued serpyanku and apply it on top of 2-3 coats of filler (with small time intervals). After drying, the solution restored the surface should be sanded with sandpaper for maximum smoothness.drywall repair

With the aim of eliminating holes with a diameter of 100 mm is used, the drywall, the thickness of which is equal to the thickness of the repaired sheet. Openings more than 100 mm should eliminate the third way. Both of these options require advance preparation and availability of certain tools and materials.

Preparing: select tools and materials

During installation of a patch of drywall you will need the following tools:

  • Construction knife or hacksaw for cutting and processing material;
  • A plane for Stripping the edges of the sheet;
  • Measuring tool (ruler, tape measure, etc.);
  • Marker;
  • Metal and rubber spatula;
  • Screwdriver or screwdriver;
  • Screws;
  • Capacity for kneading of putty.

If you install patches required to create a crate, you should prepare the pieces of wood and a saw on wood. Materials you'll need plaster and new drywall. Repair small holes can be produced using the old trim plaster sheet. If there are none in stock, they can be purchased at any hardware store.

The Nuances of putty

Going for putty, you need to clearly understand what kind of mixture you need. A in order to save prefer regular plaster, but soon regret their decision. This is because the material shrinks greatly and crack when dry, so it is better to buy a special mixture for drywall.drywall thickness

Choosing putty, note that if we are talking about the work in the bathroom or kitchen, it is best to use a cement mixture. Gypsum compositions suitable for work in a warm and dry room. If the repair is planned in several rooms, use polymeric compounds, as they are universal. When all the materials prepared, you can start to work.

How to patch a hole in drywall with a patch

If the diameter of the unwanted holes greater than 10 cm, for defect elimination should be a patch of similar material. To do this:

  • With a hacksaw handle the jagged edges of the hole.
  • Gently cut the damaged section of the sheet, giving the hole a smooth shape (square, triangle or rectangle).
  • When using the ruler to make measurements with the new hole.
  • Using a knife, all edges of holes to remove the front layer of cardboard is 2 cm Plaster mass should be left untouched.
  • Harvested On the sheet of drywall to draw the same figure, but 2 cm wider at each end. From the back of the patch around its perimeter to remove 2 cm of plaster and cardboard, leaving only the outer layer of paper.
  • Cut the drywall, the thickness of which corresponds to the thickness of the wall, to try to the hole.
  • Around the perimeter of the holes, apply plaster mix.
  • Install the patch and pressing down firmly.
  • To Align the surface and the jointstwo sheets using a spatula.
  • After drying, the solution to level the surface by sanding with emery paper.

cracks in plaster

Also allowed placing a patch method of trimming the edges of her hole at an angle of 45 degrees. In this case, the workpiece needs to handle an internal contour, and holes-outer.

Installation of the patch with the manufacture crates

Now consider how to patch a hole in drywall when its size is greater than 10 cm In such cases, you need to install a wooden crate, which will prevent the ingress of patches in the space between the sheet of plaster and the main wall.

The Process of repair is divided into the following steps:

  • Dimension of the damaged portion of the wall or ceiling.
  • Create a drawing of the future patches on a sheet of paper (on each side of the figure is stock in 2 cm).
  • Cutting patches according to the drawing.
  • Manufacturer slats of the crates. There are small pieces of wood whose length is 4 cm greater than the width of the hole.
  • Installation brackets. On the inner side of plasterboard are installed the planks (top and bottom holes) and fixed by screws at the edges of the hole, or center.
  • Installation of the patch. To set the crate fit the patch is ready and attached with screws at each end.
  • Seams and surface patches with a filler.

drywall under the Wallpaper

If damage is a large part of the sheet, it will be easier to replace the whole stove.

Finishing

After work, when the surface is plastered and smoothed, it's time to start finishing. Then you can use paint, decorative plaster and stucco, the main thing that a restored area is not conspicuous and does not attract attention. An excellent option could be the solution to hide the repaired drywall under the Wallpaper. The paper perfectly hide all the flaws of the surfaces, so from the former the damage won't be over.

A Few words about the repair ceiling drywall

Perhaps, many people know the situation, when the surface of the walls and ceilings are damaged due to flooding neighbors from above. In this case, it is rarely possible to solve the problem installing the patch, often you have to change all the drywall.

a hole in the drywall

The Repair may be much cheaper, if at the time of detection of a leak in the bottom of the suspended ceiling to make a couple of holes for moisture. Further, the disguise won't take more than 30 minutes, the entire ceiling will not have to change. If the water has affected a small area of the hinged design, it can be restored to any of the above methods.


Article in other languages:

BE: https://tostpost.com/be/hatn-tul-nasc/7273-yak-zaladz-c-dz-rku-g-psakardon-materyyaly-nstrumenty-parady-pa-ramonc.html

DE: https://tostpost.com/de/gem-tlichkeit/7274-wie-man-ein-loch-in-den-trockenbau-materialien-werkzeuge-tipps-f-r-die.html

ES: https://tostpost.com/es/la-comodidad-del-hogar/7280-como-tapar-el-agujero-en-la-pared-materiales-herramientas-consejos-sob.html

KK: https://tostpost.com/kk/domashniy-uyut/7277-alay-zadelat-dyrku-gipsokartone-materialdar-raldar-ke-ester-zh-ndeu.html

PL: https://tostpost.com/pl/komfort-domu/7278-jak-za-ata-dziur-w-cianie-materia-y-narz-dzia-porady-dotycz-ce-napraw.html

PT: https://tostpost.com/pt/o-aconchego-do-lar/7273-como-tapar-o-buraco-na-gipsokartone-materiais-ferramentas-dicas-de-rep.html

TR: https://tostpost.com/tr/domashniy-uyut/7281-nas-l-tamir-delik-gipsokartone-malzemeler-ara-lar-ipu-lar-ve-onar-m.html

UK: https://tostpost.com/uk/domashn-y-zatishok/7279-yak-zakriti-d-rku-v-gipsokartone-mater-ali-nstrumenti-poradi-po-remont.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

Cumberland - raspberry with black berries. The advantages and disadvantages of varieties. Growing raspberries

Cumberland - raspberry with black berries. The advantages and disadvantages of varieties. Growing raspberries

Black raspberry Cumberland – exotic beauty, is what sets large, dark-purple berries on the background of the familiar red raspberry varieties. This perennial shrub is capable of about 20 years to grow in one place. Its seedl...

How to make a soldering iron battery powered with your own hands?

How to make a soldering iron battery powered with your own hands?

In the work of electrician or electronics one of the important tools is a soldering iron. It can be made in the form of a handle. Such devices are sold in specialized stores. If for some reason you use a conventional soldering iro...

Copper grease: characteristics and features

Copper grease: characteristics and features

the Use of innovative lubricants improves the quality and efficiency of any equipment. In today's market presents quite a wide range of such means, however, to choose the most effective option for lubrication of specific parts wor...

All about the variety of cucumbers Luther

All about the variety of cucumbers Luther

the closer spring, the more work is involved with the garden or cottage. It is important to take care of choosing seeds, preparing the seedlings and much more. Breeders are keeping pace with the times and encouraging new invention...

How to make a blind area around the house concrete? Which grade of concrete is needed for paving? The thickness and slope of pavement

How to make a blind area around the house concrete? Which grade of concrete is needed for paving? The thickness and slope of pavement

to protect the house Foundation from groundwater and external factors, it is necessary to arrange the concrete pavement. She is around the house. This approach provides complete protection from moisture, what is not able to cope a...

Corner sofa

Corner sofa "Atlanta": reviews. Corner sofa "Atlanta" (faux leather)

Lounge – a place where the whole family gathers and where guests are received. Usually the biggest room in the house. Furniture should be beautiful, comfortable, functional, reliable.living room Sofaa Special place in the li...