How to install xenon with your hands?

The Xenon has a good light output compared with ordinary halogen headlights. Such optics shines 2.5 times brighter than standard. The xenon consumes less power and the car spends less fuel. Let the savings would be less than one percent, but it's something. Well, the main reason for the installation of such lamps, of course, is the brightness of the glow. Many motorists before buying these tools ask the question: is it possible to install xenon with your hands? As practice shows, correctly install a new bulb and adjust its illumination can be in the garage environment. How to do it – further in our article.

How to install xenon with your hands?

First we need to remove the old headlight with mounts. For this you need to disconnect the system to pull from the battery negative terminal and loosen the bolt mounting optics. After we need to apply long minus screwdriver to remove the two plastic retainer. Now we just pull out the headlight with the mounting socket.

Next remove all the wires to which it connects. A large terminal it is recommended to disconnect the small minus screwdriver. To do this, insert it into the little notch on the wire and presses on the edge of the handle. It should be noted that the terminal has a very flimsy plastic latch, so'm supposed it should  be careful.

Now remove the lid of the headlight case. Most often it is secured by 4 latches. Before you install xenon, it is necessary to extract the regular lamp. Categorically it is not necessary to touch your fingers to the reflector, as it is not the best way affect the spread of the light beam. Also during the installation of xenon avoid contact with the surface of the reflector of aggressive substances like gasoline and alcohol.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

Before you install xenon, it is necessary to consider the future location of the new bulb in the headlamp. The first is to take care of the wires. Because their will be a lot more (then you need to connect the ignition), you must do an additional hole on the back side of the optics. It is best to drill the hull bottom. So the wire will not rest against the plastic wall of the headlight. In order not to damage the plastic, first use a thin drill bit and then widen it with needle files. Now you need to thread the wire through the hole, then insert the rubber seal.

Before you install the xenon, you still have to mount the ignition. Fasten it under the headlight housing. Next, attach the remaining 4 wires, which is fed by a standard lamp. Connect all terminals according to polarity and put xenons in place of the regular.

All at this stage, the question of how to install xenon with his hands, exhausted. Now we have to close the lid and integrated optics back.

After successful installation of xenon on the first headlight the same steps produce the second. Remember that the new wires should not perejimati, otherwise the lamp will not work.