LSP lamp: purpose and device

Currently, the requirements for electric lighting sources are increasing, especially in terms of saving electric energy. Such devices include an LSP lamp (a dust- and moisture-proof fluorescent lamp). At the same level of illumination, it consumes two times less electricity than ordinary incandescent lamps. The fluorescent lighting sources installed in it have a much longer service life than the "Ilyich light bulbs".

Purpose and device

The LSP lamp can be installed both on the walls and on the ceiling. It is usually used to illuminate industrial premises where there is an increased content of dust and moisture in the air. Increased moisture protection is achieved by tightly pressing the lampshade to the base of the lamp using special clips, as well as a seal laid along the entire perimeter of the base. The lamp body is made of metal. For those rooms where tightness is not so important, LSP is used without a seal with fewer clamps, with a degree of protection IP-43. Their cost is less than that of sealed ones. The lampshade is made of frosted impact-resistant polymer glass. For ease of operation, it is attached to the metal base with a cord that allows you to hold it in the disconnected position. It is not recommended to use an LSP lamp in residential premises, but if you still decide to do this, then it is necessary to provide mixed lighting, that is, do not exclude joint use with incandescent or other lamps (for example, halogen or LED). This is necessary to reduce the harmful effect of fluorescent lighting on human vision.

Start-up control equipment

The LSP lamp is equipped with a start-up and control equipment (PRA) (colloquially, a throttle) designed to ignite and maintain the burning of a fluorescent lamp.gorenje The lamp also includes:

• Starter involved in the ignition process;
• Capacitor designed to compensate for reactive power (the system, of course, can work without it, but the efficiency will decrease dramatically).

Advantages of EPRA

The above-described elements of the lamp design have a number of disadvantages. For example, the throttle may hum during operation, the lamps flicker for a long time before ignition, and the starter creates radio interference. Therefore, now lamps with electronic controls installed in them are becoming more and more widespread. Consider their advantages:

Recommended

How to choose a bike for kids?

If a toddler insists on not putting him in a wheelchair, then it's time to find another vehicle for him. Which one? A bicycle, of course. Kids will like this novelty, giving them a sense of independence. And parents, choosing it correctly, will not o...

Women's silver watches are an extraordinary accessory

A women's silver wristwatch is an exquisite and stylish piece of jewelry. Today, even a very demanding customer can choose the right model for herself.First, you need to sort out all the samples available for sale so that you can make the right choic...

Every girl should have a good epilator

Many girls who constantly take care of themselves are forced to use a razor. This often causes irritation, and unaesthetic hairs grow into the skin. It's not a pleasant feeling. But to stop removing hair on legs, armpits and in the bikini area is not...

• Saving e. energy up to 30%;
• The service life of lamps increases up to 50% compared to those lamps in which electromagnetic filters are used;
• There is no pulsation of the luminous flux;
• Lamps turn on without delay;
• Completely silent operation;
• The weight of the device is less.

The cost of such a lamp, of course, is higher, but over time these costs pay off and give significant savings. Lighting devices are available with one, two or four lamps of different power. For example, the lamp LSP 2x36 EPRA is a two-lamp lamp with an electronic control unit. The power of one lamp is 36 watts. And LSP 2x40 lamps have two lamps of 40 watts each.

All these devices are powered by AC mains with a rated voltage of 220 V.