What turns the relay and how to repair it?

Teamwork system electric start – is the key to the normal operation of the engine. When adjusting this detail should also pay particular attention to battery, its proper connection to the circuit, because it depends on the relay of turns. His connection and adjustment require special attention and knowledge. In this article we will look at how correctly to adjust this part is what it is and what tools are needed for this.

Tools

To repair the electronic switch turns VAZ 2110-2114, you need to have a user manual, a feeler gauge and some knowledge of the unit system of engine start-up.

What is this system?

First you need to understand the structure of this device. The system electric start engine germinate the following details: relay turns the starter, the ignition switches and locks, the wires connecting the entire chain, and, of course, a car battery. Knowing this, we can safely get to work.

So, to adjust turns the relay (namely, the gap that exists between abutment and end face of the gear), you need to unplug the wire winding. They are designated by the letter “M”. Next you need to connect the battery (preferably 12V) to the coil side and another did the wire, which is marked with the English letter “S”. It is important to remember that the gear needs to move into the position of engagement. Then with the use of dipstick you should check the clearance between the stop and the end face of the gear. If there are small deviations, in this case, you need to remove or install (depending on the readings of the probe) gasket between the cover wire and the relay turns.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

To check the status of the winding, you'll need to connect to the starter schema components as described in the manual, and the wires must be disconnected from the supply of parts, marked with the letter “M”. Then connect the car battery to conclusions as it was stated in the first case. If the gear is in good condition, it must move to the position of engagement.

Another case – if you want to determine the status of the holding relay coil turns, for this you need to connect the power to “mass” and the conclusion “S”. Wire “M” should be disconnected from the battery. Thus, you will find out a faulty relay. If the gear extends, and then comes back up again several times, it means that the winding is damaged. To fix it makes no sense, the only thing that can save the situation is to replace the relay.

Board

When adjusting this system the best indicator is the maximum allowable norm values of voltage and current in the coil, which can be found in the same manual. If the current in the wires increases, it can lead to rapid overheating and subsequent failure of the system. If this figure is low, it can lead to a decrease in contact reliability. So take care of your car and expose only the voltage, which is indicated by the manufacturer.