How to bleed the power steering on the car

Date:

2020-01-01 19:20:11

Views:

499

Rating:

1Like 0Dislike

Share:

Table of contents:

Steering – it is a necessary device of any truck, which greatly facilitates management. If the power steering is faulty, then any turn of the wheel requires more effort. Like, a little mechanism and how it facilitates the work of the driver.

How to bleed the power steering, as well as what it is, and is described in this article.

Gur: the device and functions

Steering – hydraulic system, part of the steering mechanism and facilitate the control of the car.

The Main functions of steering:

  • Sustainable conservation given direction;
  • Reduced labor costs, which makes the driver to change the direction of the wheel;
  • The presence of stable connection between the wheel and the wheels.

how to bleed power steering

Gur includes the following systems and elements:

  • Dispenser, responsible for the management of the flow of the liquid in the tanks of the system;
  • The cylinder that is responsible for the conversion of fluid pressure in the well coordinated work of rod and piston;
  • Pump, which is designed to maintain the specified pressure and movement of liquid;
  • Fluid power steering;
  • Hose connections unite the parts of the system;
  • Electronic control unit regulates the power steering.

Common failure power steering

How to bleed the power steering, are described below, but for now let's consider some typical faults and solutions for the system of the GRU.

1. Unstable movement of the car on the road, you need to correct the heading direction of the vehicle additional movements of the steering wheel.

The Probable reasons and solutions:

  • The presence of the free motion of the steering wheel – if it exceeds a threshold, then adjustment is needed;
  • Wear of the elements of screw of the steering gear, if wear is present, the screw should be replaced.

how to bleed power steering

2. Damage to the pump filter, or debris in the hydraulic system penetrated the air, signs of this fact: troubled oil and the presence of foam in the tank. To solve should be flushing and bleeding the system, then change the filter.

Pumping Gur KAMAZ

In this part of the article will be discussed about how to bleed the power steering KAMAZ. The air that remains in the elements of the hydraulic system procedure after changing the oil, can cause incomplete operation of the power steering. For proper pumping system is required to perform the following steps:

  • Using the Jack, lock the front wheels in the air;
  • Unscrew the valve overlap, which is located on the steering mechanism;
  • Turn the steering wheel to the left end;
  • Fill the pump with new oil;
  • To start the engine and the smallest momentum to fill the oil tank of power steering until until the air bubbles from the tubing;
  • Pin propusknaya valve on the steering device;
  • Turn the steering wheel to the right, then return left and again to weaken propusknaya valve – for air outlet, and tighten back;
  • To make the last described procedure until the valve starts to come out clean oil.

fluid steering

How to bleed the power steering on the "Gazelle", describe below, and now let's consider the process of replacing the liquid Gur.

Change the fluid of power steering

The Fluid in the power steering system needed to be changed when soiled, and after a six-year use of the machine. How to perform this simple procedure?

  1. You first need to Unscrew the discharge hose that leads to the steering apparatus, it is necessary to restrain the nut from turning.
  2. From the system of steering is required to bleed the fluid without starting the engine, turn the steering wheel to the right and to the left until, until the liquid from the discharge hose will not cease to flow. Then re-attach the hose to the pump.
  3. Fresh fluid to fill the system.
  4. To Start the engine. At this time the liquid is gone and will be distributed through the system. Fill the system with fluid until its level will not be the same.
  5. Bleed the system WTP.

The Liquid in the hydraulic booster is an oil-type PSF, designed for the WTP.

Fluid for power steering must have the following properties:

  • The temperature of the oil to 110 degrees;
  • The presence of additives to improve the quality of work under pressure;
  • A constant viscosity under varying loads;
  • No foam
  • Preventing the occurrence of rust.

How to pumpthe steering on the "Gazelle"

Pumping system WTP on the car "Gazelle" is required in the following cases:

  • When entering the air system;
  • After performing repairs, which was followed by a depressurization system.

How to bleed the power steering KAMAZ

The Procedure for recovering the system from the air:

  1. Fill the power steering system fluid.
  2. Fix the handbrake in the up position, to put under the rear wheels of the machine brake stops. The front part of the machine to raise.
  3. Steering wheel set in the straight position. To start the engine.
  4. To the right until it stops turn the steering wheel. At this time the fluid reservoir will have air bubbles.
  5. To Turn the wheel sharp to the left to exit the hydraulic system of the remnants of the air.
  6. Repeat the procedure until air bubbles stop appearing in the reservoir. If necessary, add fluid to the maximum level.

Now, these simple procedures you will prolong the system lifetime of the Gur on the car and will long to enjoy a comfortable driving.


Article in other languages:

AR: https://tostpost.com/ar/cars/20491-how-to-bleed-the-power-steering-on-the-car.html

BE: https://tostpost.com/be/a-tamab-l/38148-yak-prapampavac-g-dra-zmacnyal-n-k-rulya-na-a-tamab-l.html

DE: https://tostpost.com/de/autos/38231-wie-die-pumpe-servolenkung-am-auto.html

ES: https://tostpost.com/es/coches/37582-como-bombear-direcci-n-asistida-en-coche.html

HI: https://tostpost.com/hi/cars/22172-how-to-bleed-the-power-steering-on-the-car.html

JA: https://tostpost.com/ja/cars/20147-how-to-bleed-the-power-steering-on-the-car.html

KK: https://tostpost.com/kk/avtomobil-der/38542-ret-nde-syrt-y-gidrousilitel-rulya-na-avtomobile.html

PL: https://tostpost.com/pl/samochody/40091-jak-pompowa-wspomaganie-kierownicy-w-aucie.html

PT: https://tostpost.com/pt/carros/39749-como-a-bomba-de-direc-o-assistida-no-carro.html

TR: https://tostpost.com/tr/arabalar/35208-nas-l-pompa-hidrolik-direksiyon-araba.html

UK: https://tostpost.com/uk/avtomob-l/38941-yak-prokachati-g-drop-dsilyuvach-kerma-na-avtomob-l.html

ZH: https://tostpost.com/zh/cars/43461-how-to-bleed-the-power-steering-on-the-car.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

Trucks Japanese: review and photos

Trucks Japanese: review and photos

the Japanese Trucks, like American, is long-established on the local roads. They are famous for good quality and long service life. Many trucks of this country are able to be not only a special means for transportation of the larg...

"Audi A3" hatchback: photos, technical specifications, owner reviews

the Majority of consumers, choosing a car, the first thing to pay attention to a compact size. Huge crossovers are gradually replaced by small hatchbacks or sedans. Blame – the comfort and economy. “Audi A3" (hatc...

The types of gear boxes: description, photos

The types of gear boxes: description, photos

today's manufacturers are mounted on vehicles different gearbox, and it is not only about automatic transmission systems. Even structurally simple mechanical boxes are divided into different styles and have features. Let's look at...

ZIS-112. History and characteristics of the model

ZIS-112. History and characteristics of the model

As is known, the USSR had a very poor range of vehicles. Sports cars almost was not, as factories focused on the production of mass products. It is one of the few such machines, the ZIS-112, history and characteristics.HistoryThis...

Trailer for UAZ. Types and purpose trailers

Trailer for UAZ. Types and purpose trailers

Popular SUV UAZ produced in Ulyanovsk can rightly be considered the most hardy Russian vehicle. This characteristic has earned it not only because of its permeability, but also capacity. Even the old “Bobby” (UAZ-469) ...