Pasting carbon fiber: necessary materials and tools, the technology of pasting

The phrase "hanging carbon" usually involve pasting self-adhesive vinyl film, imitating the texture of carbon fiber. The main advantages of using the carbon film as compared with the classical painting – less time and material costs (no need for a primer surface and do not need to wait until dry soil and paint), the ability to self-wrapping cars with carbon, a minimal set of tools. There are two types of pasting: “dry” and “wet”. Next will be described the pasting carbon fiber car parts according to “dry” way.

Tools Needed

When you work will need either: the carbon film with channels for air outlet, hair dryer (better construction, but you can use normal to dry hair), scissors, hobby knife, clean soft cloth it is also desirable that the presence of squeegee and primer for vinyl film. The thicker the film, the better it hides the irregularities of the pasted over surface, but very thick film worse glued to the ground roll, the optimum thickness of 200 microns.

Surface Preparation

The quality of the execution of this phase largely depends on the durability of the coating film. You first need to get rid of chips, cracks, dents, and corrosion centers on the surface, it is possible to use car putty. After drying, the coated filler may be necessary with sandpaper grain size no less than 300. You then need to wash the pasted over surface from dirt and degreased with gasoline or solvent.

Recommended

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

Cut the desired size piece of film this size is the square of the part and stock exposed on all sides. Stock better to take more, up to 8-10 cm for large parts. It is important that the lines of the pattern on adjacent parts were pointing in the same direction.

Pasting carbon fiber begins with straights. The exposure is made to last. Hairdryer heated film can be stretched, and thus are pasted over uneven surfaces. The air from under the adhesive film expelled with a squeegee or cloth from centre to edge. If you have a primer, they miss the edge to be pasted on the details to increase adhesion to the ground roll. The wrap auto carbon fiber is made according to the principle: one piece - one piece film. Do not overheat and do not stretch the film too much, otherwise you will disrupt the structure of its surface, such a defect is clearly visible. After pasting in a few weeks it is better not to wash the car and don't drive at high speed, to film the village and "remembered" the shape of the car.

If the air is after pasting the still left under the film, it is necessary to press the place with a damp cloth, then heat with a Hairdryer, when heated, the film shrinks and the defect will likely not be noticeable. Lining interior with carbon produced on the same principle, only the dimensions of the parts are generally smaller and they have more complex form.

If you follow these simple tips, then pasting carbon fiber car will be for you a simple exercise, and the result will delight you and your friends.