Fuses automotive

Fuses automotive – a very important part of any vehicle. For the purchase of good quality parts, I spent more than one hour, so buying this stuff is worth it to spend the allotted amount of time.

Some people are dismissive to the choice of parts such as automotive fuses. Like, what is difficult – it's just a plastic piece inside which is located the fuse element. You can buy any. But this approach is careless. If you buy a defective product, it is possible in response to two trouble.

If fuses automotive fuse inappropriately, you can leave your car without a functioning rain wiper. It's a shame and bad, but it's not the worst. The second is more complicated. The fuse may not work during the circuit. The consequences of this case quite dangerous as it can burn out the wiring (at least) or a car. The indirect cause of the problems in the car can become a short circuit. However, the main problem usually lies in such details as car-fuses. Sometimes due to the rising voltage the fuse can not stand, and the plastic case starts to melt. And this stuff could burn the whole car! In order to avoid this situation, it is necessary to consider some rules that are worth considering, when choosing such an important detail as fuses automotive.

Buy a better set, rather than individually. And be sure to pay attention to the information that was given about the manufacturer. It is listed on the package. If it is absent – it is better not to buy this set. If plastic, which made the car fuses transparent, then the host machine can detect the failure of this details visually if the fuse element will burn out. However, there are products that are made of opaque plastic, and function great standards and tolerances. Now it is necessary to pay attention to the technical requirements of these parts.

Serviceable fuses for the auto needs to carry out its work over a hundred hours at a current that exceeds 10 percent of the nominal (not allowed to melt the hull). And they should not burn! The pins allowed voltage drop of 150 mV (for fuses of 7.5 and 3.5 , as well as 15 and 10) and up to 115 mW (30 A), 125 mV (25 A), 130 mV (20). This product must operate 0.15-5 seconds (if current, which is twice nominal).

So, what to do if the fuse is still faulty? First you need to remove it from the slot, and then insert the vacant place a new one (just be sure it must be the same number). In order to remove this detail, you need to use special plastic pegs, which usually comes with the very product. However, if you take into consideration all the above mentioned recommendations, the fuse will last a long time.