The roof of corrugated Board with your hands: how to do it?

In recent years, the construction industry in our country is experiencing a rebirth. The volume of construction is constantly increasing, many people realize their dream of building their own houses.

Naturally, in such conditions the special importance is the cheapness and practicality of the materials used. So, the roof of corrugated Board with their own hands made, will not only save money on construction, but also to do so without sacrificing the quality of the Assembly.

Why corrugated?

More recently, the roofs of private houses were often covered with slate. Fortunately, this difficult and not too easy to install material in recent time have been almost completely supplanted by the cheap and functional analogs, the best of which is considered to be a corrugated sheet. this Material is lightweight, easy to install and cheap, which leads to his choice in private construction. In short, the roof of corrugated Board with your hands – a great choice that will allow you to make a home under the roof, even without having a huge construction budget.

Where to start?

Strangely enough, but before starting, you will need to measure the slope of your roof, as from the results of these measurements will depend on many things. So, when the angle of inclination up to 14 degrees, the leaves can be mounted with an overlap of 20 cm. When the steepness of the roof up to 30 degrees, this value can be reduced to 15 centimeters. Finally, size only 10 centimeters is made in the case when the angle exceeds 30 degrees. incidentally, in the latter case the roof is of corrugated Board, are made to be the most durable, as the snow it will go much better and in a shorter time.

Recommended

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

Additional materials

In Any case, don't forget to acquire damp-proofing materials. Unfortunately, many builders completely ignore this aspect, with the result that the service life of the roof is reduced to absurd values. This is especially strange, given the fact that the special “breathable” the membranes are not so expensive. these Materials are attached to the roof using construction staples and seams are sealed with special tape. Definitely need to put their overlap (15-20 cm).

Work!

Begin to put the leaves on the lower right or left angle of the slope. Note that the roof of corrugated Board with their own hands constructed, provides for mandatory withdrawal of the sheets of corrugated sheet over the eaves line. Attach them with screws 4,8х35 mm, trying them just at the right angle. For every square meter to spend 6-7 fasteners. Between the sheets are also fastened with screws, trying them every 50 cm

Useful advice! If you really limited in your budget, cover the roof with corrugated Board with your hands can be on top of the normal roofing material.

Upon completion, we strongly suggest to carefully handle all the joints with special silicone sealant. Of course, it's a pretty time consuming job, but the life of the roof will increase several times.

Ridge straps, it is desirable to use a special seal, and the skate is attached again with screws the length of which shall not be less than 80 mm. All the slices and chips of metal necessarily to be treated with mastic or enamels.

When we cut the roof with corrugated Board with your hands, we can be assured of high quality work!