The installation of the boiler in a private house. The scheme of installation of boiler

Date:

2018-03-18 22:51:22

Views:

439

Rating:

1Like 0Dislike

Share:

Table of contents:

One of the most modern ways of heating your private home is electricity. Thermal devices that consume electricity, are quiet, environmentally friendly, high efficiency and do not require constant attention from the person. Because of this, many such models can be used as additional or principal heat source.

Training tools

The Scheme of installation of the boiler is attached to the user. After examining it, you can prepare everything necessary, namely:

  • Hardware;
  • Tube;
  • Drill
  • Cable.

installing boiler

The Drill will need to perform the holes, while the hardware will fix the boiler on the wall, this also applies to the mounting strap. When selecting a cable determine the cross section. In addition to the pipe, whose diameter must correspond to the calculated data, you will need couplings and flanges. Before you will be done installing the boiler, make sure that the material in the Foundation wall will be capable of withstanding the weight of equipment.

The Location should be selected so that the side and top Assembly left space. You will need it to access when conducting repairs. It is important to ensure that the equipment was not bias at all, this can be checked using a level. It is important to ensure that the material in the base of the wall is non-combustible. For proper installation of the units should use a mounting plate. Pipelines that will be connected to the device must be calculated taking into account the characteristics of the pump.

Recommended

The most effective methods of seed germination

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

Some details

Remember that devices with low power will operate on 220 V, whereas for more powerful units need to be connected to three-phase network. The implementation of the calculation of the cable section is made in order that he could endure the power of the device, passing a current of a certain value.

electric boiler for heating of private houses

As soon As the device is connected, the system can draw water, she came to test its performance. The methods of installation of boiler differ only in that the wall models are mounted to a vertical surface, while a floor installed on a special stand or platform.

Requirements

Setting the boiler is in the utility room or furnace. In this case, none of the living casually will not be able to break equipment. This is especially true of children. As an exception to the act Tenovye boilers factory production, they can be installed in the kitchen. Power cables should not be routed under the pipes of the heating and water. If you cannot avoid this, it is necessary to protect the cable from water exposure, it can be done by mounting metal or plastic box.

installing the boiler in a private house

Setting the boiler is accompanied with connected to the pipeline. In this case, it is necessary to exclude the possibility of weighing loads other elements of the housing unit. Pipes should be well attached to the walls. It is important to observe the cross-section area of power cable, which must match the amperage and power consumption. The frame of the machine must be connected to the ground circuit.

Additional information

The Scheme of installation of the boiler will vary depending on the varieties used unit. For heating you can use Tenovye induction or electronic installation. If the installation is carried out of the boiler with the heating elements, the complete device must be a circulation pump, a heating element for hot water supply, and security and automation.

cost of installing boiler

Thanks to this design the installation can be simplified. But the induction electrode or the heat sources represent the water elements, which implies the need of an external binding.

Connecting the device to the heating system

The Installation of the boiler is accompanied by its reliable fixation to the wall. Tenovye the device should hang at the level of 1.5 m from the floor surface or more. If we are talking about the other two kinds of equipment, they can be set as low as it will be convenient to perform the strapping. The last two varieties of generators are mounted vertically.

Connect Electic boiler with circulation pump and automatic safety to heating is very simple. Output connections must be connected to the pipework with a ball valve, which is American for convenience. To return main is connected a diaphragm expansion tank, it is installed a strainer, which is also called a sump. For its easy purification in front of the sump to install optional ball valve. This will eliminate the necessity of emptying the entire system.

Reference

The installation of the boiler suggests the need for a connection for discharge pipeline. It needs to be embedded with a shut-off valve in the return pipe. You need to place it near the heat source.

installation of the boiler with their hands

Features connection to the electrode system and induction boilers

If the presence of the induction electrode or electric boiler for heating of private houses, the installation will be more complicated. The fact that such equipment is not supplemented by pumps that need to be involved in the binding separately. A special feature of these devices is that they require inclusion in the system security group. It consists of pressure gauge, safety valve and automatic air vent. The valve is configured to pressure that is specified in the documentation accompanying the equipment.

Expert Advice

Quite often an electric boiler for heating private house acts as a Supplement to solid. This creates ease of use of the equipment, which is especially true at night time when the wood burned, and make a new bookmark to no one. In this case, begins to run the electric heater to maintain required temperature in the system until the morning.

diagram of the installation of electric boilers

The Night rate for electricity is lower than daytime, so this approach can be considered appropriate. If Electic boiler with an integrated pump that you replace the induction electrode or the heater, the pumps have to be purchased and installed separately. It will be located on the reverse route.

Connecting to the electrical network

Setting the boiler in a private house suggests the need for a mains connection. Before performing these works, you must study the manual. From there you will be able to know what is the minimum cross-section power cable, what is the scheme and the mount points. In the circuit of the power circuit in the home network should include current devices and circuit breakers, which meet the values. These requirements are due to safety of the equipment. Can you explain the rule that people must be protected from electric shock.

how to install boiler

When installing the electrode and induction generators, in addition to the grid, you need to install the remote control unit and temperature sensors, between which is sandwiched the wire. These works are carried out in accordance with the scheme, which you can find in the technical passport of the equipment. If the installation of the boiler with their hands, before working with electric network, you must disconnect the voltage.

The Cost of the work

If you are sure that you will be able to correctly mount and connect the equipment, it is recommended to ask, what is the cost of installing the boiler. The price of such services by an average of 13,000 rubles for installation of the apparatus. This amount does not include the diverter comb and boiler, it will have to pay separately.

Conclusion

If you decide to purchase an electrode boiler, the heating circuit must assume the existence of a manometer, air bleeder and back pressure relief valve. The open system needs to be supplemented by shut-off valve, which is installed on the segment of the pipeline after the expansion tank.

...

Article in other languages:

BE: https://tostpost.com/be/hatn-tul-nasc/5802-stano-ka-elektrokotla-pryvatnym-dome---nstrukcyya-shema-stano-k-elektr.html

DE: https://tostpost.com/de/gem-tlichkeit/5802-installation-elektrokotla-in-einem-privathaus---anweisung-messanordnun.html

ES: https://tostpost.com/es/la-comodidad-del-hogar/5807-la-instalaci-n-de-elektrokotla-en-la-casa-privada-de-la-instrucci-n-el.html

KK: https://tostpost.com/kk/domashniy-uyut/5805-ornatu-elektrokotla-zheke-yde---n-s-auly-ornatu-shemasy-elektrokotla.html

PL: https://tostpost.com/pl/komfort-domu/5806-instalacja-kot-y-elektryczne-w-domu-prywatnym---instrukcja-schemat-ins.html

PT: https://tostpost.com/pt/o-aconchego-do-lar/5802-a-instala-o-elektrokotla-em-uma-casa-particular---instru-o-diagrama-de.html

TR: https://tostpost.com/tr/domashniy-uyut/5809-kurulum-elektrikli-s-tma-kazanlar-zel-bir-evde-retim-kurulum-emas-elek.html

UK: https://tostpost.com/uk/domashn-y-zatishok/5806-vstanovlennya-elektrokotla-v-privatnomu-budinku---nstrukc-ya-shema-vst.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

How to get rid of gnats in the apartment house

How to get rid of gnats in the apartment house

How to get rid of fleas in the apartment? To this question many Housewives trying to find the answer. The emergence of midges in the apartment can be a real disaster, as they multiply very quickly. And the favorable conditions for...

How to remove scratches from the glass. Methods and prevention

How to remove scratches from the glass. Methods and prevention

Glass is one of the most brittle materials, developed by mankind. Very often, even with the most meticulous care and careful handling, the glass is broken and cracked. Often there are scratches on the glass. This happens due to va...

What is smart outlet? Smart SMS-socket

What is smart outlet? Smart SMS-socket

the Intelligent device management system the safety and protection of the home, or the concept of “Smart home”, a long time does not sleep genius information technology. The dream of automating all of the processes occ...

Children's beds with drawers – functional solution

Children's beds with drawers – functional solution

In recent years, more and more applications began to acquire multifunctional furniture-transformer. This is due to the fact that the rooms in modern apartments can not boast of large size, and landlords resorting to all sorts of t...

Flowers gazania: pictures and description, planting and care

Flowers gazania: pictures and description, planting and care

By color gazania, you can check the time as they are revealed at noon. For this they called “midday sun”. The plant is not only bright appearance, but also the simplicity of maintenance. The flower is a real decoration...

The best varieties of raspberry: photo, title, description, reviews

The best varieties of raspberry: photo, title, description, reviews

Raspberry – unique berry. Has healing properties due to the vitamins and minerals that enter into its composition. To enjoy fresh berries to the cold weather, it is necessary to plant varieties of raspberry (photo submitted ...