Replacing the CV boot yourself

Date:

2018-03-28 17:22:08

Views:

677

Rating:

1Like 0Dislike

Share:

Table of contents:

Not every car owner knows what a CV joint. This is the abbreviated name of the CV joint, that is, devices through which the transaxle and the engine maintains traction even under the condition of full eversion of the steering wheel. This front-wheel drive car becomes more economical than the car's classic layout.

replacing CV boot

CV joint Wear is very high when turning the steering wheel, because in this state, the load on the wheel increases several times, which could lead to the departure of the wheels from the arches of the car. So competent CV joint replacement is very important. First of all, you need to ensure that cracked the cases have varied in time, and the grease fresh. Otherwise, water drops and dust will bring the CV joint from a working condition after a hundred kilometers.

such a joint

To check the status of the anthers just look at the front wheel, after removing it all the way. If corrugated rubber, located in the Central part of the wheel, a, then all normal. If not, the emergency replacement of the CV boot. In the case of ignoring problems inside the boot will get sand and dust that will damage the CV joint. Such a replacement procedure is also needed in that case, if the rubber was cracked. The failure of the constant velocity joint are easily diagnosed even without external examination: when the car goes through the bends, there is a characteristic crackling. Note that in the case of the integrity of the boot can be long enough to go with the "crunch".

Replacing the CV boot is as follows:

1. First you need to get the keys for the case, if a standard tool will not fit to tighten bolts to the wheel hubs. In addition, you should stock up on oil for adding to the transmission.

replace CV joint

2. After the training phase, you can proceed to the replacement process. Raise the front of the car, remove the wheels, setting the car on reliable support. Then remove the hub nuts of the safety pins and caps. This can only be done if the assistant will hold the brake. Then you should loosen the nuts. Replacement CV boot has the standard scheme: loosening the bolts, the complete loosening the nut, the movement of the hub on himself. There is an opportunity to remove the CV joint from the bearing and the disconnect from the transmission drive shaft. This procedure is performed in three ways.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

If you need to replace the boot, the procedure is best to start at the end of the shaft, the pre-disassembled the inner joint. First, remove the dust cover from the hinge, then three bearings. The following items for removal – the retaining ring and tranlucent. Only then it is possible to disassemble the boot outer joint Assembly through the shaft. The obtained components should be washed, cleaned from grease and oil and any faulty parts replaced by new.

3. Replacement CV boot ends after its installation, and the installation of all components. To stabilize the internal pressure in the anthers is recommended when the drive shaft is static. 


Article in other languages:

AR: https://tostpost.com/ar/cars/2827-replacing-the-cv-boot-yourself.html

BE: https://tostpost.com/be/a-tamab-l/5013-zamena-pylav-ka-shrusa-samastoyna.html

DE: https://tostpost.com/de/autos/5012-ersatz-anthere-selbst-bemessung.html

ES: https://tostpost.com/es/coches/5017-la-sustituci-n-de-la-antera-shrusa-mismo.html

HI: https://tostpost.com/hi/cars/2828-cv.html

JA: https://tostpost.com/ja/cars/2827-replacing-the-cv-boot-yourself.html

KK: https://tostpost.com/kk/avtomobil-der/5015-auystyru-pyl-nika-shrusa-derbes.html

PL: https://tostpost.com/pl/samochody/5017-wymiana-pyl-nika-przegubu-samodzielnie.html

PT: https://tostpost.com/pt/carros/5014-substitui-o-da-antera-shrusa-sozinho.html

TR: https://tostpost.com/tr/arabalar/5020-yedek-pyl-nika-shrusa-kendi.html

UK: https://tostpost.com/uk/avtomob-l/5017-zam-na-pil-nika-shrusa-samost-yno.html

ZH: https://tostpost.com/zh/cars/3058-replacing-the-cv-boot-yourself.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

Motor oil

Motor oil "ADDINOL": description, types, features and reviews

After every ten thousand kilometers, increased on odometre, the motorist asks the question: "What flood?". Of course, someone has already found a oil that is ideal for a particular engine, but someone still in search, because of t...

The biggest BelAZ - career

The biggest BelAZ - career "giant"

humanity's Need for minerals is large. Every day on our planet is produced not only oil or gas. Problem, but at the same time developed industry is mining of coal. Main place of production of this mineral-quarry. That is, the mine...

Tires Goodyear UltraGrip Ice 2: reviews

Tires Goodyear UltraGrip Ice 2: reviews

Many motorists in front of this winter had a difficult choice: they had to choose winter tires, as the old resource is completely exhausted. This should be treated seriously, because winter safety depends on the tires. Thus it is ...

Nissan 350Z: from the first to the fifth generation

Nissan 350Z: from the first to the fifth generation

Modern Nissan 350Z is a sports car, sales of which began in 2003. It is a model of the fifth generation. Let's consider a little history.Initially all cars of this family were called Fairlady Z. But the President of the United Sta...

Air suspension with your hands

Air suspension with your hands

air Suspension – is a complex engineering system that provides a low centre of gravity of the car, which gives it great stability. Its use leads to the fact that the level of ground clearance always remains the same, regardl...

Tesla dealership-Auto: reviews, promotions, loans, special offers

Tesla dealership-Auto: reviews, promotions, loans, special offers

Describing the Tesla dealership-Auto Moscow (feedback satisfied customers that guarantee), you can say a lot of good. On the distribution of vehicles that is provided in the center, you can find a huge number of different brands.A...