What is a "quick start" for the engine?

Date:

2019-12-16 12:20:14

Views:

1412

Rating:

1Like 0Dislike

Share:

Table of contents:

The Problem machine plant under low temperature conditions is familiar to many motorists. It applies both to vehicles running on petrol and diesel engines. At low temperatures, some liquids occur unwanted processes that hinder the efficiency of the power mechanism. But salvation is available. This unique product, which will be discussed here provides a "quick start" of the engine. For full no notion of his action is required to understand the factors that contribute to their appearance. Only then there will be no question about its effectiveness. Consider the root causes leading to problematic start of the engine frosty winter.

The Purchase of oils with a high viscosity index

Lubrication of slow moving parts of the mechanism, therefore, the friction elements of the main part of a car loses a desired amount of oil and do not form on their surfaces a film. quick start for the engineThe Result of the above-mentioned disadvantages will be the maximum wear and of poor quality slide components.

Voltage regulation

Sometimes when auto operation at low temperature conditions there is a voltage drop and the unit may not dial the requested number of revolutions. The consequence of this is considered problematic start of the engine. An explanation of the problem was found: high humidity conducive to unhindered the "leakage" of the required voltage. We offer a special tool able to protect the battery contacts and can easily remove excess moisture from the wires.

A malfunction in the gear - this is a very rare problem, and it is unlikely the spray will help in solving the issue.

The Presence of condensation on the contacts

Application of the product prevents the appearance of condensation on the surface parts of the parts. To resolve the problem will have to change the degree of ignition of combustible material, making it even more intense. Come to the aid of "quick start" for the engine.

Recommended

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

Inefficient activity of the power mechanism

Given the product for the minimum time will conduct diagnosis and determine the role of the power system in the breakdown by inject fluid on the inlet manifold of the engine. If the equipment is broken, when you scroll motor will appear to flash, when operating interruptions will instantly disappear. Perhaps the secret lies in the filters that were clogged. Do not ignore the fuel pump and sensors microprocessor-based device. quick start for a gasoline engineFailure is capable of leaving any detail. When using tools remember that several vspryskivaniu enough to determine the root cause of failure. If the results did not justify itself – look for the cause in another.

What is this fluid?

"Quick start" for the engine is a liquid to successfully run the power unit in any adverse conditions. quick start for diesel engineFlammable mixture favors the reduction of the temperature threshold required to fuel the fuel-air mixture.

The Main purpose of product:

· facilitating the work of the engine at temperatures below zero;

· granting of possibility of operation in high moisture and wet spark plugs;

· contributes to enhancing the efficiency of the engine with a weak battery and the low quality of fuel.

The chemical Composition of the product:

- active flammable substances;

stabilizers

- anti-corrosion additives;

- additives possessing lubricating properties that eliminate the possibility of dry friction.

The Essence of the product

As mentioned earlier, a "quick start" for the engine – spray to the smooth running of the motor. The principle of operation is to inject it into fuel for the purpose of mixing. While the qualitative characteristics of fuel starts to increase many times, which helps to improve the ignition. In result, the fuel is easy to ignite and can ignite even the slightest spark. The engine starts without problems.

Where to pour the substance?

According to the instructions, it is sprayed into the intake manifold, where it together with air will go into the power unit. quick start for diesel engineBut there are other options. Some car owners prefer to add it to the carburetor. Before spraying the liquid needs a good shake the can well to get a homogeneous structure, because in a relaxed position, he has the ability to split into heavy and light substances. The shake should be short, and then the liquid is ready to use.

If the engine is in a healthy state, then when spraying the specified element it will start definitely. If the result is the opposite – the recommended procedure is to repeat. Abuse it should not be, because your actions can cause irreparable harm to the vehicle.

How does the "quick start" for the engine? Manual step-by-step using the spray:

1. Intensive shaking of the container for 2 seconds.

2. Two-second injection of a mixture of put in Bay.

3. Start mechanism in normal mode.

4. Rethe spray element (in the case of failed attempts).

5. Check the ignition system.

When starting the motor vehicle should be aware that its performance is tested with a slightly depressed gas pedal. "Quick start" for diesel engine is required to perform a full pressed pedal of submission of fuel.

Be careful

When using the drug need to dismantle the air filter. Also when applying the product there is danger that we will explain below.

Detonation as the fuel mixture

Formed immediately after inject aerosol. quick start for the engine compositionDue to the high rate of fire, which increases the likelihood the strongest dynamic impact on the piston. The result of the experiment can be damage to the piston rings and burnt valves. Some cases involve the incitement of fuel previously laid, resulting in critical pressure and the formation of the outbreak before the appearance of sparks.

The cause of the problem: the presence in the chemical composition of the essential oil, which is the ability to ignite at low pressure. The negative influence of active elements on the parts susceptible to friction. Uncontrolled the number of active substances, entails the dissolution and removal of the film with the rubbing components power the engine, which causes dryness and can cause overheating. Statistics shows the increase of the parts of the equipment scuffing and chipping. As a result of overheating is loss oil the desired degree of viscosity that stops to linger on the details. These processes lead to the change of the coefficient of wear and tear on equipment to the maximum, the deterioration of the health of the motor.

How are things with transport diesel group?

"Quick start" for the engine (diesel) is better to use in extreme situations. Professionals avtodela say in one voice that it is strictly forbidden to do.

Why?

The Fueling of diesel fuel may occur much earlier than it should, which will lead to excessive loads on the machine components and the piston parts. "Quick start" for a gasoline engine is not terrible, but to increase the dosage dangerous. quick start for the engine injectorProfessionals propose to use the aerosol only by the long stay car in bad weather conditions. Regularly apply a "quick start" for a gasoline engine is not recommended. This significantly reduces its resource. For injection machines also questions the rationality of the use of such tools as a "quick start" for the engine (the injector in this case is not an exception).

quick start for engine manualWith him there are certain difficulties, because the motor starts it is hard to start. The cause is considered to be a small number in an input path of gasoline vapors.

The Advantages of aerosol:

· effective when the negative factors.

· does not entail the discharge of the battery;

· thoroughly lubricate all the parts subject to friction;

· prevents the risk of corrosion and has a beneficial effect on plastic and rubber parts in the power supply.

Caution is needed when:

- use diesel vehicles of the group with automatic glow plugs warm up;

- the application start element, when trying to start the engine, filled with fuel material.

So, we found all the properties of the tools "quick start" for the engine, and its composition and rules of application.


Article in other languages:

HI: https://tostpost.com/hi/cars/24376-what-is-a-quick-start-for-the-engine.html

PL: https://tostpost.com/pl/samochody/39872-co-to-jest-szybki-start-dla-silnika.html

PT: https://tostpost.com/pt/carros/39654-o-que-o-quick-start-para-o-motor.html

ZH: https://tostpost.com/zh/cars/49216-what-is-a-quick-start-for-the-engine.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

Mazda: model number and description

Mazda: model number and description

Mazda is a Japanese car manufacturer that was founded in 1920 to the present. A new range of "Mazda" in 2016 happy abundance of upgraded machines. Recently, the style and feature of the brand was redesigned. Now all the cars look ...

Model range Peugeot: description and rates

Model range Peugeot: description and rates

Peugeot is the oldest car company of French three. Under logotipom stamps were produced only cars in the late 19th century. For all time of existence the company has won in various categories and released 23 different models. Also...

Overview of the car Lada Largus Cross. Tuning of

Overview of the car Lada Largus Cross. Tuning of "Largus" 4x4 from the manufacturer

Car model «Lada» have not caused wild excitement among motorists. Of course, if you do not take into account drawings of concepts and exhibits. Technical tuning «Largus” 2012 has not produced the expected r...

VAZ-21124 jerks when accelerating: what's the problem?

VAZ-21124 jerks when accelerating: what's the problem?

what is the reason for the strange behavior of the car VAZ-21124 during acceleration and quiet driving, of interest to many motorists. The unexpected jerking on the climbs and the descents cause them to worry about the technical c...

Brake tester for passenger cars. Stand brake system

Brake tester for passenger cars. Stand brake system

What to check the brakes of the car? With the aim of analyze the condition of the brake system used 2 methods – road and poster. In our article we will focus on bench technique. Bench method controls the following settings:t...