How to install plastic window with their hands?

Windows, plastic is instantly attracted consumers immediately after its release on the market. Currently, almost nobody sets their classic wooden counterparts. Their advantage is in the fact that installing them may not only a professional with experience. After reading this article you will learn how to properly install a plastic window. So, let's start.

With the installation of double-glazed Windows features the following details:

• You can install them even in winter. However, you yourself should understand that it is best to work in warm time of the year. In addition, summer and spring mounting foam hardens better. So how to install plastic window You need all the instructions, this process may take more than one day to live in a windswept apartment is not too comfortable.
• The Need for accurate measurements of window openings. The success of the measurements depends on the success of the event.

If you want to install plastic Windows cheaply (yourself) in the panel house, you should also measure the internal opening. The fact that in such cases the box with the frames rests on the opening section which resembles the letter “G”. The measurements were carried out in the following steps:

• Measure the distance between the side jambs;
• Measure the distance from the sill to slope both sides;
• Note that the width of the sill should be equal to the width of the wall, excluding the width of the profile.

Before how to install plastic window in a brick house, should determine a bearing wall, since it is usually a thick layer of plaster. It should be taken into account by measuring the window openings.

It is believed that the easiest way to install double-glazed Windows in a wooden house, but it is not. Note that the tree – the material is capricious, easily expands and contracts under the influence of environmental factors. So to install Windows you need to okoshechka. It is independent design of timber similar to the trim of the door frame. Thanks to her, the window is not jammed and does not deform due to the "movements" of the tree.

Recommended

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

Once again: > so how to install plastic window is quite difficult, you must carefully follow the instructions.

• Pulling the plugs, get yourself a glass.
• To Mark each of them so as not to confuse with the installation.
• Remove the protective film from the ends, glued in its place a paper tape or a similar coating.
• At the end of the plastic frame glued vapor barrier tape.
• By Setting the opening the bearing pads, put them in the assembled window.
• Carefully adjust it, using the building level.
• Finally lock the box by means of metal profiles and to fill the void of quality foam.
• Set the window-sill, sills, and then carry out the installation of double-glazed Windows. Attach the plug you need to start from the top.
• Install the inner slopes, and to attach decorative profile.

If you're going to comply with all our instructions to install plastic Windows (Moscow their range will amaze anyone) can quickly and efficiently. Wish you success!