Installation of laminate flooring

Today laminate is one of the most popular consumer flooring. It's warm, beautiful, economical, easy to install.

Installing laminate flooring can be made on almost any basis: concrete slab, plank or parquet floors, linoleum and even shaggy cover (but the length of the pile should not exceed 5 mm). To lay laminate flooring along the walls or at an angle thereto.

It is used in premises with normal and increased to 90% humidity. In the latter use water-resistant laminate and adhesive bonding. When the mounting laminate is conducted on an existing wooden floor or parquet, it is better to use perpendicular stacking of the Board laminate against the floorboards.

Prior To installation of flooring from laminate need to withstand it in the room where you will be laying in the package is not less than 2 days.

The installation of the laminate begins with a survey of the base, the irregularities which must not exceed 4 mm per 2 m of length and which must be horizontal. In the case of more substantial deviations or ahorizontal base should be prepared. Concrete - pour self-leveling mortar. Wooden – to Polish and replace the Flex of the Board.

To Put laminate flooring on mineral substrates, but such a device requires a thorough vapor barrier plastic film, a cloth which is spread on overlap (up to 20 cm).

For any reason, fit the insulation or substrate of eco-friendly cork fabric or PE foam. The substrate and laminate are placed perpendicular to each other.

The installation of the laminate usually lead from the left corner of the window (less visible seams of joints) along the long wall. Nearly all laminate flooring has locking connection (collapsible or latches), which makes its installation very simple. The next Board is applied to an already mounted, its tongue inserted into the groove lie, and the Board falls. I hear a click – all is ready. Between the extreme boards of the laminate and the wall heat always left a gap of 10-12 mm, so that during subsequent operation, the coating did not buckle.

Recommended

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

At the end face at an angle of approximately 30 degrees in the groove insert the next panel and snapped, pressing her to the floor. The End joints in adjacent rows should be shifted by 30-40 cm, ie, arranged in a checkerboard pattern. This will help evenly distribute pressure on the panel. Installing laminate flooring is ‘floating” method – the panels are fixed to each other, but not attached to the base.

Quite often there is a need to put a coating directly on the floor. Is it possible? Laying laminate on the parquet is possible and quite common. In this case, it all begins with training grounds. Not very large defects of the existing flooring removed with a grinding machine. Loose planks glued or nailed, the cracks zashpaklevyvayut. If the deviation is significant, and flooring to be dismantled there is no possibility – on top lay sheets of plywood (for the level) and fixed with screws or nails. Then spread out the substrate, fit the laminate and the skirting is fixed.