The pump fell into the well: the methods and problems of lifting of the pump

Date:

2018-03-20 15:51:14

Views:

502

Rating:

1Like 0Dislike

Share:

Table of contents:

In some cases, owners of private areas are faced with the problem when the pump fell into the well. This can cause some problems. Sometimes equipment does get stuck when lifting. Incorrectly solving the problem, you may damage the device or the pipe, in some cases the well is shut down. If you have some knowledge on the lifting pump, it will allow you to save money, time and effort.

The reasons for the fall of the pump

pump fell into the well

The fall of the pump can occur for many different reasons. For example, such difficulty you may face when raising non-performing unit. It happens so that the pump gets stuck, and while trying to free him cut off the rope, cable or water pipe. At break, additional costs for lifting equipment and restore communications.

If you do not want the pump fell into the well, it is important to prevent changes in linear dimensions of the casing, tangling of the cable, the silting-up of the device. The reason for the fall is to use a plastic tether instead of a stainless steel cable. In this case, the savings is not justified — the cost rise of the fallen (often with the entire bundle of pipes and cables) of the pump exceeds the cost of the steel cable. The only option in which you can use safety wire, plastic — a shallow temporary wells and low-cost equipment, the possible loss of which you don't care much.

Potential problems

how to get the pump out of the hole

If your well is working, then after removing the pump it can be use further. When the pump fell into the well, along with the device you lost the cable, rope or hose, the source of water to use will be available. In order to avoid such difficulties, it is necessary to monitor the condition of the pipeline and safety materials. In addition, the well must undergo maintenance every two or three years.

Recommended

The most effective methods of seed germination

The most effective methods of seed germination

Despite the fact that the method of seedling in vegetable production is a very time consuming process, it is used by most gardeners. Planting seeds in open ground is an easy and convenient method, but it is effective only in certain climatic zones. I...

Retro-reflective paint. The scope of

Retro-reflective paint. The scope of

When the vehicle began to fill the road, their popularity began to gain reflective paint. Thanks to this paint, as drivers and pedestrians becomes much easier to avoid accidents in the dark. Purpose paint Reflective paint – paint material, whic...

How to make icon with your own hands - options izgotovleniya (simple and complex)

How to make icon with your own hands - options izgotovleniya (simple and complex)

In Soviet times, many collecting badges, emblems, pennants. To get them was not easy. And today, thanks to technology, you can make them yourself. Knowing how to make icon with your own hands, and you can make original gifts to your friends, and make...

How to retrieve the device

mud pumps

Before you start work on the extraction Assembly, it is necessary to carry out the preparatory work. For this you will need the following tools and materials:

  • Steel bar;
  • A crane;
  • Canvas gloves;
  • Metal wire;
  • Welding.

When carrying out such works can not do without assistance. As for the steel rod, its length should be 1 m, while the diameter – 5 mm. Preparing a metal wire, you should learn what the depth of the well. This information is presented in the passport. It is important to take care of the cut wire, the length of which is equal to the depth of the well. To this value you should add 5 m. the Diameter is the same as a steel rod.

Procedure

rig

If the pump fell into the well, then you must correctly perform all work according to his recovery, to continue to use the water source. When the equipment falls inside the hose, then first remove it. To do this, hook the item with the rod, which is called “cat”. It is important to sharpen the ends and weld to the hook of the metal wire with the welding machine. The other end of the wire must be fixed to the arrow of the crane.

Well, you should lower the hook and rotary motion, to be able to hook the hose. Manipulation will be carried out blindly, you will not see if the hook to hook the hose. If the goal is reached, the pump can be removed with a lift. It is important to carry out the work with a safety net, to avoid trouble.

You should Not skimp on preparing the cable. If it will have bad quality, it could simply break. Therefore, it is recommended to purchase stainless steel cable. If you have a question about how to get a pump from a well, you should not use rope, which is made up of several pieces. The segments may diverge in this case the device does get stuck.

To reduce the risk of jamming should buy the pump of a lesser thickness, for the price these models are more expensive, the drilling of new wells is not cheap pleasure. It is important to take care of the installation of protective devices, then the inside will not get foreign objects and debris.

What to do if the pump is stuck when retrieving

pump fell into the well what to do

Some owners of water source on his land in certain circumstances wonder about how to get the pump from the well. In this task, you may encounter another problem, which is expressed in the exterior of the pump. This can occur when the slack of the electric cable, whereby to form a loop. It gush to a device and jams between the walls of the well.

To Raise the Assembly using a Jack or hoist in this case is not possible. Sometimes it happens so that the rope is dropped. If it is not using rope, cable, hose or pipe, it is important to ensure that all elementscame along.

The Master should ensure that slack does not arise for the cable, neither on the tube nor on the hose. If this happens, the pump needs to push down again, grabbing hold of the pipe or hose. In the next phase it is recommended to raise the device, but very slowly. If the equipment cannot be lower down, you should choose between the value of the well and cost of the device. After all, if the pump falls from an impressive height inside, when it rise there's no guarantee that it can be repaired or reused. Therefore, some home masters decide to sacrifice a unit, but to save the well.

The pump Lift of unexploited wells

what is the depth of the well

Sometimes crash on the well lead to the fact that they no longer use. Over time, you might face the task of lifting a pump from a well that has not been used for 2 years or more. Usually under such conditions, the sludge rises above the pump. When you try to lift the unit, it can jam.

Raise the equipment in this case in the build. Will have to pull and loosen the rope on which hangs the device. Steps should be uniform. This method sometimes helps to detach the unit from sludge, which fits snugly enough it. If this happens, the water will flow into the gap and will thin the sludge, allowing for easy operation.

Such manipulation should not be accompanied by the application of excessive effort, because otherwise the cable may break and the pump to fall. Subsequently the well can be used, but only in the case when the water in it is fairly transparent.

The fall of the pump in the sump

sump well

If a sump well is sufficiently large, and the pump fell back without additional elements, it is possible and not to take any action. It is important to ensure that the device was below the level of the filter. For this purpose, the load and ropes, it is recommended to explore the bottom of the sump. This situation is the simplest that occurs when you drop a submersible device.

How to avoid errors

Even If after all the recommendations you are unable to achieve the desired result, and the pump remains at depth, then you can take the help of professionals. Removing a fallen pump, the specialists can incur costs, but to save money today wants every consumer. However, as practice shows, the economic benefit from the extraction of the pump with your hand is imperceptible compared to the cost that would be required for drilling new wells.

Sometimes consumers call derrick, but even such professional help is able to permanently destroy the well. This suggests that even with the assistance of special equipment, all attempts to extract the device can be unsuccessful. Many actions only lead to the fact that the unit is compacted and goes down. But experts emphasize that the measures to recovery pump sometimes help to identify problems. Sometimes a drilling rig is not only helps in solving the problem, but also damage other equipment and elements of the well.

Problems when lifting

If even by a slight raising of the cable or the cable is not slack, but the device was stopped by the solid object, then the solution is to try to understand which could cause interference. Drilling pumps and installation are also not always help. After all, if on the surface there is no cable, wire and hose to solve the problem is possible only with the help of experts. Sometimes they come for work only in the case when we are talking about industrial well. Because this operation is quite expensive, in some cases it turns out to be unprofitable, and the technique destroys only source of water is used then there is no opportunity.

If you are trying to solve the issue, then the jamming of the pump problem may be the protrusion of the casing. Among the most common interference should be highlighted:

  • The remains from welding work;
  • Flash;
  • Dent;
  • Expense of a joint of pipes.

Self-lifting can be carried out very slowly, making a rotational movement, it is necessary to grasp the pipe or hose. You are lucky if the pump will slide off obstacles and slip it on the problem area. When inside fall, it can block.

The gaps between the apparatus and the walls of the well are small, so even the small objects able to jam the device. In this case, can help not only drilling pumps and installation, but videodiagnostika. Such cases are the most difficult. It is best to entrust the matter to professionals, selecting up the slack of the rope, pulling it at the maximum height, and after strengthening and leaving in this state until the arrival of the brigade of professionals.

Conclusion

Quite often, consumers today are wondering about what to do – pump fell into the well. If he was on the limestone, then proceed to work yourself is not recommended. Better to use the videodiagnostika, which will determine damages, the condition of the pump, and pipes, and to understand whether inside of objects.


Article in other languages:

BE: https://tostpost.com/be/hatn-tul-nasc/19398-pompa-zval-sya-shchyl-nu-sposaby-prablemy-zdymu-pompy.html

DE: https://tostpost.com/de/gem-tlichkeit/19410-die-pumpe-fiel-in-das-schl-sselloch-m-glichkeiten-und-probleme-heben-d.html

ES: https://tostpost.com/es/la-comodidad-del-hogar/19420-la-bomba-cay-en-el-pozo-m-todos-y-problemas-de-elevaci-n-de-la-bomba.html

KK: https://tostpost.com/kk/domashniy-uyut/19397-nasos-lap-yma-a-d-ster-men-m-seleler-k-teru-sor-y.html

PL: https://tostpost.com/pl/komfort-domu/19358-pompa-wpad-do-studni-metody-i-problemy-podnoszenia-pompy.html

PT: https://tostpost.com/pt/o-aconchego-do-lar/19363-a-bomba-caiu-no-po-o-m-todos-e-problemas-de-eleva-o-da-bomba.html

TR: https://tostpost.com/tr/domashniy-uyut/19404-pompa-d-t-kuyuya-yollar-ve-sorun-kald-rma-pompas.html

UK: https://tostpost.com/uk/domashn-y-zatishok/19393-nasos-vpav-u-sverdlovinu-sposobi-ta-problemi-p-dyomu-nasosa.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

Double vanity for bathroom: the benefits and types of

Double vanity for bathroom: the benefits and types of

Many of us have seen the interior design of bathrooms in the United States. Very often Americans apply a double sink. In our homes this solution is gaining popularity. Whether it is necessary to resort to this method? In some case...

Concrete slab: weight, thickness, length

Concrete slab: weight, thickness, length

in the construction of multi-storey buildings using different materials. However, an integral element in any such facilities are concrete slab. Ceiling in houses made from them, ensure the reliability and safety of construction. T...

Linoleum tile will suit any interior

Linoleum tile will suit any interior

For many years linoleum remains the most popular floor covering. Despite the huge selection of new modern high-tech materials, it is still popular among Russian consumers.the Linoleum tile is the ideal material. It has proven itse...

Projects of houses of lightweight aggregate concrete blocks: to build stylish living

Projects of houses of lightweight aggregate concrete blocks: to build stylish living

Modern suburban building – ability to build a structure that will be vastly different in appearance and layout. Today on the site it is possible to realize almost any design idea, the most important thing – choose the ...

The best recipes: how to make jumping at home

The best recipes: how to make jumping at home

did you know that the beloved skipjack more than a thousand years? Different Nations used the ball for the ceremonies and, of course, for games. But became really popular rubber “bounce”. And opened it to the world Chr...

Installation of acrylic baths with their hands: manual

Installation of acrylic baths with their hands: manual

to Choose and buy the bath is only half the battle. The end result will depend on the quality of installation of the product. Proper installation will allow use of plumbing fixtures for a long period of time with maximum comfort. ...