What should be the tire pressure of the ATV?

Fans of the drive behind the wheel should pay attention to the fact that motorcycles have become increasingly flickering in the reports of the accident. Therefore it is necessary to be serious about safety standards and maintenance of machines, for example, regularly measure the tire pressure of the ATV. In addition, this parameter causes the correct balance of equipment, grip, normal handling and integrity of the tread. ATV – off-road equipment, and the normal condition of the wheels gives it the performance at movement on rough terrain. Therefore, only optimally matched and well pumped tires will allow you to enjoy a fast and safe drive.

The Strategy of choice of tires for motorcycles

What to consider when choosing tires for an ATV in the first place? Of course, the tread pattern which offers grip and stability both on straight track and on curves. If you buy the tires used, it is necessary to consider the degree they wear and rubber, and relief. Incorrectly chosen products reduce the maneuverability of the transport and its power. You must know that the tires of the ATV diagonal design, rather than radial, as in a conventional vehicle. These products are made of several layers of cord, stacked each other perpendicularly. The pressure in the tires of the ATV must be low, thus protected off-highway equipment.

Contact Area of motor vehicles and soil

The tire Pressure of the ATV provides such an important figure as “contact”. The normal rate determines the optimal size. For example, if the pressure is low the “contact” great, and therefore, the protector will quickly deform, weaken the grip, motor starting "walking" bad “holds” relief and does not listen to the driver. If the figure is high, that is, the camera is overinflated, the contact of the ATV and the ground is reduced, decreasing the level of flexibility the sidewall of the tire and significantly reduced attenuation. Only optimally inflated tires provide excellent maneuverability, good speed, stable, stability, the necessary shock absorption and riding safety.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

Features of movement on various routes

Which path would you have chosen for riding on the motorbikes, before driving on the track you need to check the tire pressure of the ATV. When choosing a trip, you need to understand that when traveling on different types of surfaces need different indicators. Soils can be hard: concrete, asphalt or dense soil. The road can be more gentle and moving: the off-road, sand or snow. What pressure in the tires of the ATV must be provided in either case? When traveling on the road recommended indicators from 0.35 to 0.83 bar. If you have to travel on a hard road, pressure better increase of the nominal value by 25-40%. Some drivers in the first case, it is recommended to swap the rear wheels a little more.

Tire Pressure CFmoto

One of the most popular ATV - CFmoto. It is often used in various test drives to determine the optimal parameters of those indicators. That is, at the start of the tire pressure of the ATV CFmoto is set according to the standards, and then on the route to change it and make measurements. Indicators from 1.1 to 1.5 bar is optimal for movement on the asphalt as for better maneuverability and tire wear. Decreased rolling resistance on the road. But on the off-road areas, a meeting with the bumps felt much tougher. In General, the pilots concluded that if most of the route runs through a dense coating in the chambers to better support high blood pressure.