Led daytime running lights

Found more and more car owners who have already installed or intend to install on my car the daytime running lights. They are so much like drivers, thanks to its main features-very strong brightness. Lights glow so that their day can be seen better than on the low beam.

What advantage have daytime running lights

1. Low energopotreblyaemost. In conjunction with the rear size, front lights consume 130 watts, and the led light strip – 14 watts. The result is obvious. The less energy consumption, less fuel consumption. So everything has its use. 
2. Terms of service elements of navigation lights is also significantly higher than the effect of the bulbs, which need a large number of frequent use.
3. In the end, the beauty of its inferior conventional bulbs navigation lights.

The Only drawback-a rather high price. Not everyone can afford such jewelry. The cost of some individual items – from 3 to 5 thousand, and the whole set is 9 to 11 thousand rubles. Plus the installation. Despite the cost, the market provides a very wide range to choose from, and therefore, the daytime running lights are in demand.

What is very important to pay attention to when purchasing:

1. Select the form block. To do this, consider the shape of the bumper, the structure and design of the entire vehicle.
2. The Blocks are also of different size. Determine the place on the car, on which you will install the lights, then the size will become more clear.
3. Note the total wattage of the LEDs around the block.

Daytime running lights - installation

The Installation of navigation lights may cause certain difficulties and even seem a problem. As a rule, the place to do this, choose next to the headlights or in the voids existing on the bumper. For these installations it is often necessary to make cuts and drill holes. But not only do you need to fix daytime running lights on the same level with the bumper so they were not, so also should be the right way to carry out wiring and connect them so that when you turn the engine they were on fire, and with dipped headlights went out. All work performed must meet the requirements in accordance with GOST.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How to carry out installation work with his own hands

Technology for which the installation is carried out vary depending on the kit that must be installed on the car. Each of which is attached and installation instructions. In it, the manufacturer clearly specifies the schema to connect lights to their correct operation. In addition, each comes with a set of necessary parts for installation work.

Here are some requirements according to GOST:

1. Installation of navigation lights is strictly prohibited on trailers.
2. The Scheme, which made installation of lights on the vehicle shall comply with the requirements designated by the manufacturer.
3. Automatic switching on and off lights when the engine is started.
4. Install the diode lights on the vehicle is allowed only with the front part and toward the light ahead.

Observing certain technical rules, set led daytime running lights on your car and use them on the roads!