Replacing the brake discs "Kalina" with their hands: special repair

Date:

2020-02-03 03:00:11

Views:

496

Rating:

1Like 0Dislike

Share:

Table of contents:

You Need to replace the brake discs "Kalina" approximately every 70-100 thousand km of mileage. But can this procedure be done earlier if the elements has worn to the minimum thickness. To repair even a beginner, there is nothing complicated. You only need the minimum set of tools, no puller and the specific fixtures you will not be useful.

The Symptoms of the fault

To determine the damage, you need to listen to the braking system – if the car is to the side when you stop, it indicates the presence of faults. But just need to make sure that the wheels are inflated to the minimum pressure and the pads healthy. Check the thickness of brake disc – a healthy it should be more than 17.8 mm. If less, then you need to change disks. And be sure to replace the brake discs "Kalina" on both sides – this will ensure maximum efficiency and uniformity of operation of the system. Be sure to install the new pads in the Assembly.

replacing the brake disk Kalina

Tools for work

To independently perform work on the replacement of brake discs of "Lada Kalina", you need to acquire such tools:

  1. Set of keys. You need to be in the process of compression, carob and mechanical on “7”, “13”, “17”.
  2. Flat screwdriver. Preferably a few Grand in the process to choose the most convenient.
  3. Hammer and a wooden block.
  4. A Jack of the hydraulic or pneumatic type.
  5. Key cylinder on “19” (or “17”, depends on what the bolts installed on the wheels).

Definitely need to fix the car on level ground and under the rear wheels to place the stops.

Recommended

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

replacing brake discs Lada Kalina

The Dismantling of mechanisms

Before replacing front brake discs on "Kalina" need to disassemble the whole unit. For this you need to follow a few simple steps:

  1. Loosen the wheel bolts and lift the repaired side by means of a Jack.
  2. Fully Remove the front wheel and lower the car on reliable support. Try all work to be carried out on the supports, the jacks, even the most reliable, do not trust.
  3. Now you need to disassemble the brake. Bend the plate of metal, which are the bolts on the caliper at the top and bottom.
  4. Remove the two bolts using the key on “17”. If the inside nut will be turned, will hold its second key on the “17”.
  5. Disconnect the hose from the rack, not to tear during the work.
  6. Lift the caliper and move it aside. Attach to body as possible from the workplace.
  7. Remove the front brake pads.
  8. Remove the two bolts that secure the hub and the caliper body.
  9. The Key to “12” you need to Unscrew the conical guides that attach to the hub of the brake disc. If not get them to Unscrew, apply penetrating lubricant.

replacing the front brake discs on Kalina

Removing a drive and inspection

When carrying out repairs, do not push the brake pedal – will lead to the expulsion of the piston from the caliper. The result will have to change, and these mechanisms, and even to Prime the system. After unscrewing the guide you need to remove the brake disc. This can be done with a special puller or a proven method – with a hammer and wooden spacer.

But usually when replacing brake discs on the "Kalina" with his own hands did not have to resort either to the first or to the second method. The disc is easily removed with your hands – the metal does not take a strong liking to the wheel hub. After dismantling inspect the disk surface – it should not have cracks, waviness. If permitted by the thickness, we can machined wheels – it will be a little cheaper than buying a new one.

But if you had to endure a disappointing sentence elements, you will need to install a new one. It is advisable to purchase vented – to distinguish them just because the design consists of two halves. Better to give preference to such manufacturers: Ferodo, Textar, TRW, Brembo. However, the cost of them is higher than from Russian "AVTOVAZ".

replacing brake discs at Kalina own hands

Add new disk

The Sequence of actions is:

  1. Install the new drive and align the holes in it and on the hub.
  2. Engage, then tighten the guide conical studs.
  3. Install the fixed part of the caliper on the hub, tighten the two bolts with the key on “17”.
  4. Install the new brake pads. Please note that you will need the caliper completely drown inside the piston. Otherwise, the new pads do not deliver.
  5. When replacing brake discs "Kalina" be sure to check the status of all the elements – this will avoid repairs for a long time.
  6. To drown the piston, you need a little priming to Unscrew the fitting.
  7. Install the moving part in place, the guides need to be processed with silicone grease. It is able to withstand large temperature, in contrast to the "Licola" or "CV joint".
  8. Install the two bolts, if necessary, hold the nut insidethe key for “17”.
  9. Fold the edges of the metal plate.

The repair is over, you can install the wheel and enjoy the ride. When braking, the car will not carry on in the direction.


Article in other languages:

AR: https://tostpost.com/ar/cars/21127-replacing-the-brake-discs-kalina-with-their-hands-special-repair.html

HI: https://tostpost.com/hi/cars/23669-replacing-the-brake-discs-kalina-with-their-hands-special-repair.html

PL: https://tostpost.com/pl/samochody/40633-wymiana-tarcz-kalina-w-asnymi-r-kami-opis-naprawy.html

PT: https://tostpost.com/pt/carros/40183-a-substitui-o-dos-discos-de-freio-cranberries-com-suas-pr-prias-m-os-c.html

UK: https://tostpost.com/uk/avtomob-l/39683-zam-na-gal-m-vnih-disk-v-kalini-svo-mi-rukami-osoblivost-remontu.html

ZH: https://tostpost.com/zh/cars/48400-replacing-the-brake-discs-kalina-with-their-hands-special-repair.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

Range Rover Sport: tuning, restyling, body kits

Range Rover Sport: tuning, restyling, body kits

the British car industry, many associated with luxury and comfort, and waiting for potential buyers. The model range of the British manufacturer boasts not only a presentable appearance but also decent facilities. Today's article ...

"Vesta" or "X-ray" - which is better? Comparison of cars features, reviews owners

Immediately after the start of sales of Lada Vesta has caused a stir among motorists. Many of those who were looking for a car in budget price segment, began to consider this model in more depth. In the end, most motorists preferr...

Road marking machine for road marking: types and description

Road marking machine for road marking: types and description

the First attempt to use road markings recorded in England (1921). This system is still in use today, ensuring the safety of pedestrians and the orderly movement of vehicles. To accelerate and facilitate the process of drawing sig...

Hyundai IX35: reviews.

Hyundai IX35: reviews. "Hyundai АХ35": the shortcomings of the model and problems during operation.

the Car "Hyundai АХ35" the reviews are mostly positive collects. It is reliable and comfortable Korean car, which is intermediate between the expensive cars of the highest class and budget SUVs and crossovers. Based on the reviews...

Car alarm

Car alarm "Tomahawk 9010": function, installation, instructions

the Range of alarm systems "Tomahawk" one of the first in the domestic segment has acquired the function of remote engine start. The coming of the new option was held for more than 10 years ago, and it is clear that toda...