Antenna for cellular communication. Antenna to enhance cellular communication

Date:

2018-03-21 19:35:20

Views:

563

Rating:

1Like 0Dislike

Share:

Table of contents:

Modern life is hard to imagine without mobile devices. However, cellular communication is not available everywhere. To solve this problem, installed a special antenna. On the towers and roofs of the houses are prefabricated device. Additionally, there are amplifiers for cellular communications. In order to more thoroughly understand them, it is necessary to consider specific models.

antenna for mobile communications

The Antenna for AP-800

Mounts the specified cellular antenna on the roof. Running it through reflector. He set single channel type. Also, the device uses two vibrator. Directly connecting bus is used with the extender. The minimum frequency of the specified antenna does not exceed 340 MHz. Sector interference depends on the height of the installation.

The Input impedance presented model does not exceed 12 Ohms. To operate the device at very low temperatures. To mount it, there is a special AC plug. Directly extender in this case, the loopback type. Setting of antennas of cellular communication is happening at the front.

antenna to enhance cellular

AP-860

Using two vibrators is provided cellular. Antenna on the house are fastened by stanchions. Reflector the device uses a three-band type. This model has a lot of power and limit its frequency reaches 800 MHz. The gain in this case equals to 12 dB. Sector of radiation in the device is large. It is also important to note that the model is used as connector for connections. The minimum frequency is 230 MHz. In sub-zero temperatures, the model can be used.

Recommended

IPTV settings

IPTV settings "Rostelecom". IPTV channels

Analog TV is gradually disappearing into the background. His place faster pace is a free IPTV Rostelecom. And it's really convenient, because digital channels to look better because of better picture, sound. But first you need to clarify some points....

IMEI: how to change the phone yourself

IMEI: how to change the phone yourself

If you need to change the IMEI on your phone, this article will provide complete and correct information about what is IMEI code, what is it for, and how to change it.What is IMEI you May have already encountered this concept, then you know that the ...

Washing machine Bosch MAXX 4: operating instructions

Washing machine Bosch MAXX 4: operating instructions

All well-known manufacturer of Bosh, before you present to the world another new, not only conducts many tests, but uses all available methods to ensure maximum safety. To washing machine MAXX 4 pleased his master as long as possible, the set to her ...

AP-855

Installed these antennas on residential buildings. The specified modification is made on the basis of a loop extender. The reflector in this case a single-channel type. In total, the device has three vibrator. The stand is made with an extension cord. The maximum frequency is located at 890 MHz. The rate of gain is equal to 12 dB. Connecting bus of the model installed with the Converter. To stabilize the frequency is Converter.

cellular antenna on the roof

Description MIMO 2

Install the cellular antenna on the roof. This modification is made with two vibrators. In this case, the reflector is applied a two-channel type. Just the model, there is one connecting bus. Converter from the antenna is missing. Converter, the device has a coaxial type. The loop expander has a higher operating speed. Set the model on the rack. In this case the minimum frequency of the antenna is 120 MHz. Input impedance it is able to withstand a 5 Ohm. At zero temperature the model is allowed to operate. Sector of radiation in this case depends on the height of the installation panel.

Options MIMO 5

This antenna is made with a dual reflector. The rate of gain is around 30 dB. It is also important to note that the device has a panel for fixing. All vibrators have four. The connecting bus is used with a Converter.

The standard Converter installed coaxial type. To connect the device, there is a special AC plug. Extender antenna have provided a loop type. The minimum frequency of the device is around 300 MHz. The radiation sector is around 50 degrees. The high input impedance of the system can withstand 20 Ohms.

Device strengthen AL-900-14

The Specified antenna to enhance the signal produced on the basis of the tetrode. In this case, the comparator uses a condenser type. The coefficient of dispersion models is 80 %. The power device does not exceed 22 watts. Extender the model is not used.

Problems with crosspolarization solved by the installation of the stabilizer. The minimum frequency of this antenna is 120 MHz. The thyristor in this case is not provided. The rate of radiation equals 35 degrees. It is also important to note that to connect the device connector is used AR.

the installation of cellular antennas

Antenna AL-900-77

The Specified antenna works by tetrode, which is installed with amplifier. The comparator in the model there is a condenser type. The parameter minimum frequency is around 50 MHz. The radiation sector in this case does not exceed 45 degrees. Vibrators have antenna do not exist. The thyristor is used odnoimennogo type. The input impedance of the model is quite high. It is also important to note that the gain parameter is equal to 10 dB. The maximum allowable temperature of the antenna is 45 degrees.

Device AL-900-90

This antenna is the antenna with the capacitor comparator. The tetrode in this case there is no amplifier. Directly to the thyristor is used odnoimennogo type. Just got two of the reflector. The input impedance of the antenna is quite large. The minimum frequency is 120 MHz.

Directivity Factor does not exceed 50 dB. Extension by the manufacturer with the horn type. The maximum allowable temperature is 40 degrees.

cellular antenna on the house

Model 1815 ANT LY

This antenna works on the comparator capacitor. Tetrode the model is provided with odnomomentnym thyristor. The standing wave ratio does not exceed 80 %. Problems with crosspolarization are due to the vibrators. The connecting bus is used in the device with the Converter. The coefficient of dispersion depends solely on the height of the device.

It is Also important to note that the minimum frequency is around 340 MHz. The maximum allowable temperature of the model is 45 degrees. Crosstalk in this case is due to reflector.

Description ANT 3540 LY

This model is made with a single-channel reflector. Comparator is applied directly to the condenser type. Just got one tetrode. The minimum frequency modification is at the level of 200 MHz. Problems with crosspolarization the specified antenna is not terrible. The maximum frequency of the device is equal to 340 MHz. Vibrator the model is used with connecting bus. However, the Converter in the antenna is not provided. Expander is used the loop type. Sector of radiation of the device is equal to 45 degrees. Factor enhanced action does not exceed 33 dB.

Options Wilson

This antenna is made with one vibrator. The reflector she had mounted two-channel type. The connecting bus provided by none. If we talk about parameters, the gain is around 45 dB. In turn, the minimum frequency is equal to 230 MHz. To connect the antenna has the AC connector. The maximum frequency is 450 MHz. The thyristor of the model installed odnoimennogo type. It is also important to note that the device has a compact comparator. The extension in the antenna is missing. The minimum allowable temperature is 40 degrees.

antenna to enhance the signal of cellular communication

Antenna AO-900

This antenna is made on the basis of odnoimennogo thyristor. The comparator used in this case is a condenser type. The dispersion of the model is quite large. It is also important to note that the maximum frequency is 230 MHz. However, the rate of amplification is only 12 dB. The reflector in the antenna a single-channel type.

Connecting bus installed in the unit without a Converter. Extender it provides. However, there is a qualitative loop extender. The connection uses an AR-type connector. The radiation sector of the model presented is equal to 45 degrees. Crosstalk is due to the tetrode. The standing wave ratio is at 90 %.

Device AO-566

This antenna is made on the basis of a simple comparator. The tetrode is applied to the amplifier. The maximum frequency of the device is 30 MHz. The dispersion in this case depends on the height of the installation. The minimum frequency of 122 MHz model. Extender manufacturer provides the loop type. In total, the device has two reflector. The vibrator used in this case only one. The input impedance modification is at 35 Ohms. The height of the impedance depends on the weather conditions. The maximum permissible temperature of the modification is equal to 45 degrees.

Model AO-780

The Specified single-band antenna has a reflector. The comparator uses only one. The amplifier in this case is along with a vibrator. It is also important to note that the antenna uses loop-extender. The connecting bus at the specified modification is missing. Directly figure the minimum frequency is equal to 230 MHz.

The extent of dispersal depends on the height of antenna installation. Problems with crosspolarization be solved with the help of the amplifier. The maximum frequency of the device is at 450 MHz. Minimum permissible temperature is -30 degrees. The radiation sector is around 65 degrees. The maximum permissible temperature is 45 degrees. The input impedance of the model is quite large. Factor enhanced action does not exceed 5.5 dB.

Description Link ANT-457

This antenna to enhance cellular communication is performed with a single-channel reflector. The comparator in the device is a tetrode. The thyristor used in this case is low power. Directly minimum frequency does not exceed 300 MHz. It is also important to note that the rate gain is 4 dB.

The Minimum allowable temperature modification is at elevation -30 degrees. The coefficient of dispersion depends on the installation height of the reflector. Crosstalk from antenna, if necessary can be adjusted. The standing wave ratio does not exceed 70 %. Amplifier in the present device is not provided.

antennas on residential buildings

Options Link ANT-200

This antenna to enhance cellular communication is made with one reflector. The connecting bus from modification is used with the Converter. Directly Converter installed coaxial type. The antenna connects to the network via the AU plug. The power of this device equals 33 watts.

The Input resistance it can withstand a maximum of 13 Ohms. The maximum allowable temperature is 40 degrees. The comparator in this case is absent. It is also important to note that the model has two vibrator. Tetrode manufacturer is not provided.The standing wave ratio in this case does not exceed 6 dB.

Summing up

Considering all the above, it should be noted that houses are often used modification panel type AP-800. A distinctive feature is the high frequency parameter. On the towers used antenna MIMO series 2. Among the devices amplification can highlight the Link ANT-457. This antenna has high settings and is very compact.


Article in other languages:

AR: https://tostpost.com/ar/technology/6257-antenna-for-cellular-communication-antenna-to-enhance-cellular-communi.html

BE: https://tostpost.com/be/tehnalog/11158-antena-dlya-sotavay-suvyaz-antena-dlya-zmacnennya-sotavay-suvyaz.html

DE: https://tostpost.com/de/technologie/11163-antenne-f-r-den-mobilfunk-antenne-zur-verst-rkung-des-mobilfunkes.html

ES: https://tostpost.com/es/la-tecnolog-a/11167-antena-para-telefon-a-m-vil-antena-para-el-reforzamiento-de-la-telefon.html

HI: https://tostpost.com/hi/technology/6263-antenna-for-cellular-communication-antenna-to-enhance-cellular-communi.html

JA: https://tostpost.com/ja/technology/6260-antenna-for-cellular-communication-antenna-to-enhance-cellular-communi.html

KK: https://tostpost.com/kk/tehnologiya/11162-antennasy-yaly-baylanys-antenna-k-sheytu-sh-n-yaly-baylanys.html

PL: https://tostpost.com/pl/technologii/11155-antena-telefonii-kom-rkowej-antena-do-wzmocnienia-sieci-kom-rkowej.html

PT: https://tostpost.com/pt/tecnologia/11151-antena-para-telefonia-celular-antena-para-amplificar-o-celular.html

TR: https://tostpost.com/tr/teknoloji/11167-anten-h-cresel-anten-kazan-h-cresel.html

UK: https://tostpost.com/uk/tehnolog/11158-antena-dlya-st-l-nikovogo-zv-yazku-antena-dlya-posilennya-st-l-nikovog.html

ZH: https://tostpost.com/zh/technology/6781-antenna-for-cellular-communication-antenna-to-enhance-cellular-communi.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

AHD camera: mount and customize

AHD camera: mount and customize

Many users interested in how to upgrade the existing surveillance system in accordance with the latest standards. Currently, for high-quality image is sufficient to establish the AHD.Let's look at one relatively “young&rdquo...

SUPRA DRS-iG68VST - model review, reviews of customers and experts

SUPRA DRS-iG68VST - model review, reviews of customers and experts

today in Vogue radar detectors. More and more devices appear with the location feature. Even with the fact that they have a higher cost, such devices enjoy the highest demand. And this feature has nothing to do with the emergence ...

Smartphone ZTE Blade L5 Plus: reviews

Smartphone ZTE Blade L5 Plus: reviews

today's digital market has a huge range of budget smartphones. Almost all of them are somehow being used by someone as a “calling” and some lack them and to realize their full capabilities. In this paper we consider on...

How to stick the film on the phone (photo)

How to stick the film on the phone (photo)

Each mobile device, whether smartphone or tablet, today has a large touch screen. To manage such a gadget, of course, only touches on this screen. And this, in turn, causes pollution perfectly clean display surface, the occurrence...

"iPhone is disabled, connect to iTunes" - what to do?

When you purchase most often we choose a reliable device, but in the process often encounter many errors. Some are caused by software failures and other incorrect use. Commonly the screen indicates: “iPhone is disabled, conn...

The culprit is not always funny. Who are the culprit and why victims of prank often do not understand their humor?

The culprit is not always funny. Who are the culprit and why victims of prank often do not understand their humor?

In the modern world, phone, mobile or stationary, has long ceased to be only a means of communication with family and friends. It is actively used for the active promotion of the Bank's customers, regular surveys are carried out. ...