The Cars of domestic production are reliable and quite durable, despite the fact that they are widely abused. Low cost, availability of element base – key factors when choosing a machine. But every driver is trying to improve his iron horse, so for the beauty and reliability often put disc brakes on the rear VAZ-2114. Yes, it is beautiful – drum look pathetic on alloy wheels. And reliably – the brake efficiency increases several times in comparison with the standard equipment of the car.
Since the release of the first car factory in Togliatti, but it was a model "VAZ-2101", popularly known as “penny”, almost to this day, the circuit of the braking system all vehicles remained unchanged. Ahead was a raised disc and rear drum. This is logical, as the main load when braking is necessary on the front.
Of Course, this scheme is much more efficient than that of the GAZ-24, which stand in a circle with drums. Because it's not a secret that the disc brake pads grab much better, and the way to the stop, respectively, is much smaller.
The VAZ-2114 – this is a fairly recent model, which replaced the famous nine. Base cars are the same, even little things like the rear lights, and those are similar. But to significantly improve the machine yourself.
It is Worth noting that "Lada Kalina" - this is the first model where the factory installed it disc brakes on the rear axle. And we should also mention that all changes to your car, you do this entirely at your own risk. Intervention, modifications, steering, brake system, shall be punished with removal of license plates and prohibition of operation of the vehicle. But if you are not afraid, you can continue reading.
Recommended
"IZH 350 Planeta Sport" – frisky Soviet bike
It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...
How does the rear bushing front arm and how many it serves?
The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...
Oil consumption in the engine. Six reasons
It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...
If, however, decided to put disc brakes on the rear VAZ-2114, need to know what it will require elements of:
Well, that's all, bought all of the parts available all the necessary tools. It remains the case for small – to carry out a complete redesign. It should be noted that a fairly new VAZ-2114 (their price on the secondary market is still high) do not have rear brakes, but easily altered.
Before disassembly of the entire brake system on the rear axle must be drained. For this twist prokachannye fittings located on the calipers. Therefore, in the future will have to do the pumping. Initial work is as follows:
Please note that the handbrake no longer will you have (if you do not install hydraulic). Therefore, all components that are somehow related to the cable, including its, can be removed. And now we need to talk about the installation.
The location of the caliper mechanism can be both in front of and behind the axis of the rear wheels. It will work anyway, but if you set back the efficiency a bit higher. Next, in your task is to correctly produce the matching of the hub faceplate. Pay attention to the defects, even minor ones. If there are gaps, guide the work on re-docking.
Guide the alignment of the corners of the rear beam. No this will not work to put the rear hub. It is most convenient to carry out the alignment using the grinder. To install the disc brake caliper, need to do some more actions:
That was it, overall, as you can see, the job is simple. But caution must be exercised when installing, only use new items, especially the bolts. It is unacceptable to use the bolts that were in use. Thread they already deformed, though it is not visible to the naked eye.
Yes, the main plus – an increase of security. Reduced braking distance, and it does not depend on the weather. A node is stable, the weather does not affect it. For example, during rain drum brakes become ineffective, the braking distance is extended. When using such a disk is not observed.
Overheating is not a terrible disc designs. For example, when braking at high speeds the liquid in the system heats up due to high friction forces. Drum and pads can warm up almost red hot – up to 600 degrees. As a result, fails the pedal, the braking performance significantly deteriorates. You will never feel if disc brakes are installed. The device is simple and the reliability is high, therefore the safety can not worry.
After all the work needed to make leveling – getting rid of air in the system. It is very necessary to improve efficiency. And since I started the upgrade, then do not forget to change all components that serve for a long time. Replace the hoses, front pads, vacuum booster VAZ-2114, master cylinder. As for fluid, you should change it approximately every two years. Briefly, the bleeding procedure looks like this:
Here's how to bleed the brakes of VAZ 2114 correctly, the essence of the procedure – to go from the far to the middle caliper (relative to the master cylinder).
But some motorists can not do without the handbrake. A new VAZ-2114, which at the time was close to 300 thousand, without handbrake, and is not very convenient. In cities without Parking it just anywhere. And if you set the auto-start system, without the handbrake simply can not do – the speed set is not recommended.
You need to install this mechanism? In the first place – it is the handbrake, but not cable actuated, and hydraulic cylinder. As a rule, they are universal, and Chinese new mechanisms in cost from 1500 rubles and above. And rear disc brakes on VAZ 2114 will be equipped with hammer system.
The installation process is extremely simple – put it in place of the old, fasten bolts, connected to the hydraulic system, namely – to the part which operates calipers on the rear axle. That's all, now you will with the handbrake, which will perfectly work in any conditions. Not afraid of any overheating, no frost, no rain pouring. And even in the cold, you can use the handbrake.
When will be fully completed installation and pumping, adjust brakes, inspect carefully all the knots, tighten threaded connections. And after the first exit on the road you will feel the difference with the same braking. It will be much more efficient, the car will become more stable.
I Must admit that this revision is necessary, and the traffic police should allow them, albeit with reservations. Kolhozah not, at least acceptance of the work and permission to use should give an experienced master. Of course, this dream will not happen. So you have yet to rework entirely at your own risk.
But the fact – disc brakes on the rear VAZ-2114 efficient and reliable. And install them you will only win, to protect themselves, their passengers and pedestrians.
Article in other languages:
AR: https://tostpost.com/ar/cars/962-vaz-2114.html
HI: https://tostpost.com/hi/cars/962-2114.html
JA: https://tostpost.com/ja/cars/961-vaz--2114.html
TR: https://tostpost.com/tr/arabalar/1651-fren-disk-arka-vaz-2114-yedek-elleriyle.html
UK: https://tostpost.com/uk/avtomob-l/1647-gal-ma-diskov-zadn-na-vaz-2114-zam-na-svo-mi-rukami.html
Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."
Related News
During Soviet times, “Volga” was an unattainable dream of many citizens. On these machines went to the higher ranks of leadership and celebrity. With the collapse of the Soviet Union, the dream has become a reality &nd...
Starting the engine – start motorist
Now on the roads of the city can be seen as vehicles of a new type, and outdated models. They differ from each other not only in appearance, but have different device and the progress of the work, thus starting the engine in the c...
Nissan AD, reviews and features
Nissan HELL – one of the cars of the Japanese company Nissan, produced from 1999 to 2006. This model is available in five-door five-seater wagon.Nissan AD. Features:the Car was produced with engines 4-types of volume from 1....
French truck Renault Mascott ("Renault Mascot"): specifications, equipment, reviews
With the purchase of small commercial vehicles often raises the question of the choice of the brand – domestic or “Ino”? Many people come to the selection of domestic ‘Gazelles’. They are more afforda...
Salon "UNIX-the Car": responses. Divorce in the showroom Uniks - true or not?
Expensive purchase – it is always an exciting moment for any person. Car buying is no exception. If the process runs perfectly, any person will be happy. Most people prefer to postpone after a certain period of time a certai...
Motorcycle "Yamaha Diversion 600": specifications and reviews
See a bit of history. In 50-ies of the last century, in the postwar period of technological development the world famous Yamaha finally resumes the production of motorcycles. The first model of Yamaha Diversion was released in 198...
Comments (0)
This article has no comment, be the first!