How does the ignition of VAZ 2110?

The ignition switch 2110 – it's not very complex in design and robust enough detail. However, the latter characteristic often applies to imported cars. The domestic auto industry is unable to produce such a castle, which would not fail at the most inopportune moment.

It is noteworthy That the design of this parts similar imported models, except those with a special key card. The ignition switch 2110 is composed of two elements. This mechanical anti-theft tool that locks the steering column shaft, and a contact part which connects the various circuits of electrical equipment.

Device VAZ lock:

1. Lock rod.
2. The body of the ignition switch.
3. Contact the disk.
4. Shoe.
5. Contact detail.
6. Cushion.
7. Wide protrusion contact parts.

The ignition switch 2110 is in its construction of the case, comprising all the above elements.

How to check the serviceability of the part?

Diagnosis is done by checking the details on the correctness of the circuit in different positions of the key. Also taken into account the operability of the protective device 2110. The ignition switch if it is out of order, changing completely or partially (in this case, it acquired a new larva). However, the owners recommend buying a whole piece, so you do not mess around with the installation of the lock cylinder. Here you will have to pay more money, but you can save a lot of time. With the purchase of only one mechanism, i.e. the larvae, you will spend a few hours to install it, it will save your money. The final decision of course is yours to make.

Recommended

"IZH 350 Planeta Sport" – frisky Soviet bike

It is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the line went down the fir...

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How to remove the ignition switch 2110?

If the item turned out to be faulty, it should proceed to the disassembly, for the vehicle can be started only with the pusher. First we need to prepare the tools. They are not very much. All we need is a TORX T20 screwdriver and a flat blade.

Preparing the tools, you can begin to work

First remove the negative terminal from the battery and Unscrew the 2 nuts that connect the lower and upper steering column shroud. We then remove and then extract the ring transponder. Next, disconnect the harness wires. Now looking under the dash the harness to the ignition switch. Remove it from the holder and move the latch to the side. So we disconnect the pad. Next to replace the ignition switch for VAZ 2110, insert the key and turn to ¼ of a turn. On Vases “tenth of the family” this position should be between labels “And” and “M”. Remove wiring harness of the ignition switch from the instrument cluster trim panel. Then you need to find the bolts securing this item. The nuts securing the ignition switch also needs to extract and then to remove the item itself using a small minus screwdriver. Take out all the wires from the ignition switch and proceed to the installation of new parts. It is produced in reverse order.