"the Gazelle" "Next" (pendant) is mounted with the thrust rings. Most experts say that a specified modification in the first place quality spring. It is also worth to note the strong bridge. The brackets are at the top of the rod. In the lower part of the suspension is broad seal.
Pendant "Next" ("Gazelle") is made with the front spring, which is made with two uprights. The brackets in this case are fixed on the sides. Experts say that the seals you can always change yourself. If to talk about disadvantages we have to mention the low post. In front of the spring is the bushing. Under it is a wide disc, which is fixed on the screw.
Rear spring from modifications made with two thrust washers. Bracket is used with one clip. Experts say that a ring change is quite simple. Directly front is made of small height. Only on the rear springs is equipped with three bushings. About the struts they do not RUB. It should also be noted that the spring has good stability. During the lining wears out very slowly. A tightening screw used screw connection. If we consider the back part of the modification, it is applied the sealer. From the bridge it is at a safe distance.
The mounting brackets (photo pendants (Gazelle) Next below), in this case, connect the front and rear axle. The screws in the device used a small diameter. For removing brackets and used the keys. In the rear suspension detail is set with a protective ring. The screw in this case is installed with a patch. The bracket on the middle bridge is used of high hardness.
Pendant "Next" ("Gazelle") is the middle bridge, which is made with two stops. If we consider its strengths, it is worth noting the compactness of the disk. Also the experts say about the strength of ties. To repair the bridge using special clamps. To disconnect all fasteners in the first place removed the omentum. Additionally you will need to remove the cover.
The Shoe in this case do not need to touch. Some experts say that the trim on the bridge quickly erased. The cylinder may be deformed. The model has a fairly low load capacity. Caps in this case is made of alloy cast iron. Some motorists believe that the hub is very poorly recorded. The clip under it is matched to the small width.
Pendant "Next" ("Gazelle") is made gland, which is located under the center post. Sleeve under modification selected medium width. If you consider the front of the seal, there is a short adapter. It should also be noted that under the Bush is the longitudinal strut, which is fixed on the frame of the suspension. In order to disconnect, first remove the cap. Additionally, experts note the strength of the bottom bracket, which is mounted on the packing glands. This element requires periodic lubrication. It is additionally necessary to mention that the pads used rubber.
Replacement rod suspension is fairly simple. With this purpose, immediately procured the keys under the lid seal and a hammer. In the first place detached puff. After this matter a little to knock out the front rack. The next step extracted directly nuts. Next, you need to detach the Shoe. The bracket on this touch is not necessary.
Tie the suspension is fixed quite rigidly. To separate it from the frame, you must use the crowbar. Only after that we can get to the fasteners of the bridge. Stand under it and picked up the small width. The fixation rod is carried out on the three screws. Additionally it is important to remember that ring before installation should be cleaned thoroughly and re-lubricate.
The Front suspension ("Gazelle") "Next" is done with support rings that are behind the seal. For inspection of parts necessary to remove the cover and check first the condition of the ties. This would require only one key. If the cover visible defects need to be replaced. Most suspension problems are observed with an adapter. The brackets thus can be deformed. Also we must remember that to clean the rack havevery carefully. Rings are removed from the tie up. The Shoe does not need to be unscrewed. If the clamping screws are too constrained, you can use the hammer. Additionally, we must remember that the disks on the rear suspension are attached to the support.
When damage to the gland suspension repairs (Gazelle) Next you need to start with inspection of the lower frames. In addition, you have to check the post. The Central panel must be securely fixed. If she leaves, the ring must be tightened directly. It should also be noted that the problems often lie in the adapter. The stuffing box it is installed behind the front bushing.
The Clip under it picked up a screw type. When this connector is used to the small width. In front of the seal it is necessary to immediately clean the recess. The screws are detached very carefully. Directly rack it is prohibited to knock out. The thickness of the metal in this place is not very big. At the departure of the screed checked the integrity of the springs. The stepladder is inspected for damage. If the problem lies in the lower disk, the screed can not touch. However, we must remember that the bracket can only be removed after the connector.
Pendant "Next" ("Gazelle") has a lining that is quite simple to change. It is enough to disconnect the front spring. Experts say that the thrust ring can not touch. However, to prevent them also can be viewed. If the adapter visible defects, you can try to fix yourself with a hammer. You can also try to clear the workpiece on the machine. Experts say that small cracks you can always cover up.
At the end of the ladder is treated with lubricating oil. The connector is thoroughly clean. Most motorists spend the time to replace the pads. During this process we must remember that the Shoe must be clean. The Central nut clamping cap no need to tighten until it stops.
The Cover on the suspension quite often flies. This happens due to the fact that the spring can not handle the load. To correct this situation, you can try to explore the cap and check connection. If it came off the part with the bridge, the rack can be re-weld. The selected connector and screw type. Some suspension roof flies at the base. In such situation it is necessary to completely clean the rack.
Rear suspension (Gazelle) Next is the ladder, which is under the spring. The rod passes through from the top. To explore the specified item, remove the protective cap. This suspension additionally includes a top plate. It is fixed at the base of support. Strut in this case is not in contact with the cover. Ties with suspension removable with a key. The clips on the front frame do not exist. It should also be noted that the fingers tightened very firmly.
To unclench, you will have to use a pair of pliers. Some experts say that the Shoe also needs to be replaced. As a result, the wizard will be able to fully inspect the front of the rack. Defects on the wall frames must be fully twist the cap. If the problem is in the gaskets, removed only the upper part of the lining. The spring does not need to touch.
Article in other languages:
AR: https://tostpost.com/ar/cars/20447-pendant-next-gazelle-photo-repair.html
BE: https://tostpost.com/be/a-tamab-l/35636-padveska-nekst-gazel-fota-ramont.html
ES: https://tostpost.com/es/coches/36020-colgante-next-la-gacela-la-fotograf-a-la-reparaci-n-de.html
HI: https://tostpost.com/hi/cars/19776-pendant-next-gazelle-photo-repair.html
JA: https://tostpost.com/ja/cars/20096-pendant-next-gazelle-photo-repair.html
KK: https://tostpost.com/kk/avtomobil-der/35235-salpynsha-nekst-gazel-foto-zh-ndeu.html
PL: https://tostpost.com/pl/samochody/33603-zawieszenie-next-gazela-fotografia-naprawa.html
PT: https://tostpost.com/pt/carros/33919-pingente-next-gazela-foto-repara-o.html
TR: https://tostpost.com/tr/arabalar/34964-s-spansiyon-yeni-ceylan-foto-raf-onar-m.html
UK: https://tostpost.com/uk/avtomob-l/34966-p-dv-ska-nekst-gazel-foto-remont.html
ZH: https://tostpost.com/zh/cars/17692-pendant-next-gazelle-photo-repair.html
Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."
Related News
"IZH 350 Planeta Sport" – frisky Soviet bike
it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...
Front axle MTZ-82: circuit, device and repair (photo)
Front axle of the tractor MTZ-82 is manufactured with a leading reducer. The model fitted the strip and there are metal stops. Most experts believe that the device has a solid rack. Disks have modifications apply gear type. In ord...
The scooter for disabled and elderly people: tips for choosing
Scooter for disabled is a safe and convenient mode of transport, which can enhance the ability of movement. Control it as simple as possible, since the wheel is installed in any position, comfortable movement is provided by an inf...
DRL (daytime running lights) in the vehicle can be connected through the generator or relay. In this case, it is necessary to take into account lamp power. Standard scheme involves the use of a extender for the four outputs. The i...
Car "Lexus-450": description, specifications, reviews
“Lexus-450” exists in two different versions. First – a diesel car, which is still in the name of the prefix LX. The second is a hybrid. Each of these models in their own good and unique, but also enjoys unquesti...
The car "Audi A3": owner reviews, specifications and description
Compact novelty is somewhat unique car. After all, this is the first car in the entire range of the group «Volkswagen», in which it was decided to put modular “Dolly” MQB. By the way, one of the features of...
Comments (0)
This article has no comment, be the first!