The distributor - what is it and why is it needed?

Date:

2019-12-10 15:00:12

Views:

471

Rating:

1Like 0Dislike

Share:

Table of contents:

In this article you will learn about this element of the car as the distributor. What is it and why is it needed, what types there are, what are the basic principles of its functioning, you will learn from this material. Domestic cars have several kinds of the ignition system – contact, contactless, microprocessor. If you look at the history of the development of all these systems, it is possible to detect that there are intermediate modifications. But they are usually not widespread. For example, the contact-transistor in which the interrupter switches low-voltage circuit area.

Contact ignition

distributor what is it

A Good example – it's the system and the distributor 2106. On “classics” was used only pin-ignition models from the VAZ-2109, were the only electronic. If you close your eyes on all the flaws, you can see the obvious advantages of the contact system – the simplicity and low cost. No complicated and scarce elements, but the reliability of those that are set extremely low. And all this is due to the fact that a lot of friction present in the system. Sometimes for no reason, no reason at all start to lose spark, the engine is “which”, has become unstable.

In this case, the perpetrators may be two – the carb or the ignition. In particular, the distributor – what it is, why this behavior it causes? The fact that the contact group is constantly in motion. In addition, between Cams is constantly a spark, which leaves them Nagar. Because of this, loses contact, changing the set clearance. And the best way out of this situation – the panel replacement and adjustment of the gap.

Recommended

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

Electronic (contactless) ignition

distributor VAZ

It can be found on the car VAZ classic series of the second half of 90-ies of the issue as well as on all machines beginning in 2108, released until the early 2000's. the fact that in the early 21st century began to actively use the injector of the injection system, and to control them requires a somewhat different design of the ignition. The main difference between contactless system discussed above-the lack of contact breaker.

Instead, the distributor 2109, for example, is equipped with a proximity sensor operating on the Hall effect. All management is done on circuits with low current and voltage. The required pulse frequency sets the Hall sensor, but it is a single trigger wire to the switch. Besides, it is used for the tachometer in the dashboard. Please note that some people make a kind of theft deterrent. The wire from the tachometer through the secret switch is connected to ground. As a result the ignition not fully working.

Adjusting dis

distributor 2109

The VAZ-2108 and newer that have electronic ignition, and set the time advance is very simple. The most important thing – is install camshaft and crankshafts on labels. Please note that incorrectly it is impossible to put the distributor (what's that, you already know). The fact that it is installed on the camshaft in one position, rotate 90 or 180 degree is impossible.

distributor 2109

So when put marks on the shafts and set the belt timing, you can start fine-tuning. The distributor should be located on the axis so that the mark on the head cover unit is opposite the middle line. In this case, the spark advance is 0 degrees. Rotating the distributor housing clockwise or counterclockwise, you can change the lead angle in the smaller or big party. To make these actions provided that you have at least a strobe.

Design distributor

distributor 2106

The Distributor, or the distributor (what it is known to every motorist), consists of several elements. First, it is a metal housing. It is made of aluminum alloy, it has a positive effect on the level of protection from interference. Second, the rotor of the distributor, which is connected to the runner and the camshaft. Thirdly, the runner, which has two contact – external and internal (in the center). On the internal high-voltage current with external it removed, and goes to the contacts in the distributor cap. Between internal and external contacts is a resistance. It is necessary for the absorption of interference. Inside the case there are several elements – the Hall sensor, the vacuum and centrifugal controls ignition angle. All these elements allow to operate the engine in normal operation under all conditions.

Conclusion

Now you know where the distributor used the WHA and how it happens. On modern cars this mechanism is completely disposed of, since all control feed the spark occurs through a complex system of sensors and actuators. And adjustment of the lead angle takes place only by modifying the software in the electronic control module.


Article in other languages:

AR: https://tostpost.com/ar/cars/20203-the-distributor---what-is-it-and-why-is-it-needed.html

BE: https://tostpost.com/be/a-tamab-l/37889-trambler---shto-geta-takoe-dlya-chago-en-neabhodny.html

DE: https://tostpost.com/de/autos/37510-trambler---was-ist-es-und-wof-r-wird-es-ben-tigt.html

ES: https://tostpost.com/es/coches/37271-trambler-qu-es-y-para-qu-es-necesario.html

HI: https://tostpost.com/hi/cars/21919-the-distributor---what-is-it-and-why-is-it-needed.html

JA: https://tostpost.com/ja/cars/19857-the-distributor---what-is-it-and-why-is-it-needed.html

KK: https://tostpost.com/kk/avtomobil-der/38271-trambler---b-l-ne-zh-ne-ol-ne-sh-n-azhet.html

PL: https://tostpost.com/pl/samochody/39787-zegar---co-to-jest-i-do-czego-on-jest-potrzebny.html

PT: https://tostpost.com/pt/carros/39434-trambler---o-que-e-para-que-necess-rio.html

TR: https://tostpost.com/tr/arabalar/34758-trambler---nedir-ve-ne-i-in-gereklidir.html

UK: https://tostpost.com/uk/avtomob-l/38671-trambler---scho-ce-take-dlya-chogo-v-n-neobh-dniy.html

ZH: https://tostpost.com/zh/cars/31818-the-distributor---what-is-it-and-why-is-it-needed.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

BMW 3 series (BMW E30): specifications and photos

BMW 3 series (BMW E30): specifications and photos

BMW E30 – this is the car of the second series, which was initially released as a sedan. Presented was the first model in 1982 in November. The presentation took place in the UK, and then the machine made a splash among peop...

"IZH Jupiter 2" – the specifications

not to overstate the contribution of the Izhevsk factory in the development of motoring. The first models of “IL” were added and was surprised at motopark. “IZH Jupiter-2” is the baby that at its two endure...

Strong vibration at a set rate: causes

Strong vibration at a set rate: causes

Many motorists are familiar with the problem, when the set speed there is a vibration. The reasons for this phenomenon – mass. Often the source can even drive a motorist crazy. Let's consider the main causes of shaking, we w...

Transmission CVT - what it is? Automotive transmission - a variator

Transmission CVT - what it is? Automotive transmission - a variator

Just to have a car is not enough, it is also important to understand what is in it and how it works. Of course, no one requires from an ordinary driver to have a thorough knowledge of the principles of the internal combustion engi...

"Mercedes S63 AMG 2" (coupe): technical features, description, review

“the Mercedes S63 AMG” – this is a car that is the most powerful and most dynamic among all sedan cars. It sets completely new standards in terms of dynamics, economy and technology. In General, the car is more t...