Why go to the dressing the engine? Solutions to problems and recommendations

Date:

2020-01-06 08:00:14

Views:

521

Rating:

1Like 0Dislike

Share:

Table of contents:

Sometimes the engine spontaneously revs. Values can reach the maximum possible. This situation is not controlled. The driver can even not immediately understand what had happened. This phenomenon is very dangerous. Especially among diesel engines. Many experienced motorman to call them ‘the engines of the devil”, although in reality this situation is called differently. Gasoline engine with such "behavior" behave the same as diesel. Experienced drivers in such cases we say that the motor has gone rogue. Let's find out what sends the separation motor and how to deal with this problem.

Characteristic

So what does “the engine is in the dressing”? The picture is not pleasant – the diesel unit is gaining momentum rapidly, they are constantly and uncontrollably growing. Arrow instantly goes into the red zone.spacing engineAll this is accompanied by a terrible noise, black smoke, soot, sometimes from the exhaust pipe bonus flame. All of this suggests that the engine goes into the dressing, or rather, is not, and has already come.

Why is it dangerous: the size of the risks

There are Always two options for the development of this not too pleasant situation. And here, as always, one option is extremely dangerous in itself, the second – very unpleasant. If the spacing engine is in motion, then the machine turns into a raging beast. The car accelerates quickly and suddenly. In the worst case this will lead to accidents, perhaps even deaths. In General, the outcome of the situation depends on the level of the driver, his skill and adequacy. It is here that can be useful are the skills that are taught in courses of extreme driving.dressing the engine what it is and how to fixIn the second case the situation is slightly different. The car is in the Parking lot or the Parking lot, the transmission is in the neutral position. The engine going at maximum speed, continue to rotate until, while or will not stop or just fail. By the way, smoke – a minimal impact. Most often from a sudden high loads the engine just breaks into pieces. Depending on some conditions if the power unit breaks out. At first, from high stress to pop off the cylinder head, then the engine would spit out the rest of the details on the Parking area or Parking.

Recommended

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

Causes

In the dressing the engine can take for several reasons. They are different for diesel engines and carburettor (while this petrol unit at risk). For a better understanding of the causes necessary to recall the principle of operation of diesel engines. The fuel is under air pressure in the combustion chamber. To ignite no sparks or anything else. While in the combustion chamber is air, diesel fuel will successfully ignite and the unit will work. Consider the main issues that provoke the separation of the engine. The reasons are varied, but many of them.

Fuel rail injection pump

This part in the pump may jam. The pump is driven from the engine shaft through the gearbox. If the rail jam, the unit will stall or will be sharply to gain momentum. Diesel fuel poured into the combustion chamber under sufficient pressure.why the engine goes into the dressingNaturally aspirated not physically have time to respond to the situation with the desired speed. As a result – overheating, after which bent the valves and melted pistons. If you do not jam the motor in this state, it can explode.

Faulty turbine

Compression in the engine can reach 28-36 atmospheres. This means that at the end of the compression cycle will increase the temperature. If turbine has some fault, then oil will inevitably leak, but it tends to burn. Diesel fuel mixed with oil. And in the dressing the engine there is a full program in itself is gaining momentum, noise and smoke. The oil pressure increases, and then the grease also goes into the cylinders. So the motor works as long as will heavy smoke. Even the dressing can provoke high load.

The electronic accelerator pedal

On early cars it has become a frequent cause of problems. Modern motors is no longer scary – here alone ECU restricts or increases the amount of fuel entering the cylinders. Enough fractions of a second, to take the necessary and right decision. The driver should take care about is that the combustion chamber had no oil.

Piston rings

If the rings on the pistons are worn, then it happens depressurization.the engine into the dressing what to doOil flows freely into the cylinders through the ventilation system of the crankcase gases. It is connected to the exhaust manifold. If the rings are bad enough, then Carter gets too much pressure and the cylinder formed pairs. It is a vicious circle. And the chances that the engine is “go crazy”, increase.

Why this happens and what to do?

The problem with getting oil in the exhaust manifold can be quite dangerous. It is the cause of fires in the exhaust manifold. Also as a result of overheating the engine jammed. And as already noted, the motor andis destroyed due to high mechanical loads. So, why the engine goes into the dressing, we clear. The reasons may be different, and to eliminate this phenomenon it is important to know what provoked this behavior of the motor. If from the exhaust pipe belching out thick black smoke and the revs rise quickly, most likely, the problem lies in the turbine.what to do if the engine went into the dressingOne of the typical reasons of failures of turbo - leaking oil. In this case, even if you turn off the engine it will still run on oil. Overheating will occur in the event of a breakdown of Reiki the injection pump. It is possible to define the characteristic black color of fuel in the return line. Also it will be bubbling.

How to stop the motor if he went into the dressing

It is Necessary to know what to do if the engine went into the dressing. This will help preserve the life of the engine and owner. So, to stop dressing, it is necessary to reduce the flow of fuel or to completely remove the air supply. If the situation got out of control in the process of movement, then the best solution – the load is increased. This step will help to normalize the work. If you start the dressing, and the driver is behind the wheel, he will feel the sudden acceleration. You need to remove the foot off the gas and hitting the brakes – it is important to monitor cars in the back. Here the main thing - to prevent the accident. Experts do not recommend to appreciate the engine above human life. Let him go “all” and rotating at a speed close to insane.separation of the engine causesYou Can put the transmission into neutral – the car will cease to gain speed. In any case, you need to pull over to the curb. If the car is equipped with automatic transmission, do not panic. Such transmissions also have a neutral gear, it can be set manually. Some boxes may even help to stop the car on the go.

If you have fear

And the car failed to stop, but so far the engine goes into the dressing. What to do next? If there is a fear (and it may be – a situation not ordinary), then you can leave it to work for rpm.the engine goes into the dressingWhen some fuel run out, or the knots just will not stand excessive loads. It is also better to warn others about the situation.

If there is no fear

When there are no fears, we must act. Should clearly know what to do if the engine went into the dressing. Here everything is simple. You need to kill the engine. Of course, after turning the ignition key it does not stall. The fastest way – to use a fire extinguisher. The contents of the tank sprayed everywhere in the engine compartment. The carbon dioxide replaces the air and it is not suitable for operation of the unit. This will cause the engine to stop. Also this approach can help if flammable gases began to leak into the atmosphere around the machine. When the exhaust pipe out clouds of thick black smoke, it is better to step away from the car away and urgently call emergency services. If there is no fire extinguisher, then you can try to manually block the access of air to the cylinders. Suitable cloth, plywood, or anything else. If the intake manifold is closed and the motor is still running, this suggests that the air somewhere is. If the vehicle is equipped with manual gearbox, put it on maximum transmission and trying to stop. This will give great resistance, and the engine should stall.

What to do after stopping the engine

If a "infernal machine" failed to stop, not worth the risk to try again to start the motor. If the problem is caught the driver in a way, it is better to leave the car somewhere safe, turn on the alarm system and to use the services of a tow truck. Further, the way lies in the HUNDRED, by skilled craftsmen.

How to prevent the disaster?

Those who even once saw the dressing of the engine, what is it and how to fix it, know and recommend undergo. It is also necessary to monitor the performance of fuel injection pump, a centrifugal regulator, turbine and time to change consumables.


Article in other languages:

AR: https://tostpost.com/ar/cars/18937-why-go-to-the-dressing-the-engine-solutions-to-problems-and-recommenda.html

BE: https://tostpost.com/be/a-tamab-l/30327-chamu-syhodz-c-u-raznos-ruhav-k-sposaby-vyrashennya-prablemy-rekamenda.html

DE: https://tostpost.com/de/autos/30342-warum-raus-in-die-umkleide-motor-l-sungen-und-empfehlungen.html

ES: https://tostpost.com/es/coches/30373-por-qu-sale-en-la-conducci-n-del-motor-m-todos-de-soluci-n-de-problema.html

HI: https://tostpost.com/hi/cars/16995-why-go-to-the-dressing-the-engine-solutions-to-problems-and-recommenda.html

JA: https://tostpost.com/ja/cars/19137-why-go-to-the-dressing-the-engine-solutions-to-problems-and-recommenda.html

KK: https://tostpost.com/kk/avtomobil-der/30288-nege-keted-t-pteu-oz-alt-ysh-sheshu-t-s-lder-problemalar-zh-ne-synymda.html

PL: https://tostpost.com/pl/samochody/30169-dlaczego-odchodzi-w-roznosu-silnik-rozwi-zania-i-wskaz-wki.html

PT: https://tostpost.com/pt/carros/30191-por-que-sai-em-velocidade-excessiva-do-motor-resolu-es-e-recomenda-es.html

TR: https://tostpost.com/tr/arabalar/34145-neden-gider-ay-rma-mesafesi-motor-z-mler-ve-neriler.html

UK: https://tostpost.com/uk/avtomob-l/30267-chomu-yde-v-roznos-dvigun-sposobi-vir-shennya-problemi-ta-rekomendac.html

ZH: https://tostpost.com/zh/cars/16693-why-go-to-the-dressing-the-engine-solutions-to-problems-and-recommenda.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

Isuzu Trucks Forward

Isuzu Trucks Forward

For commercial purposes they use trucks, which are manufactured by various companies. One such car is a universal Isuzu Forward.Features of models“Forward” refers to the 6 generation of trucks produced by the company &...

BelAZ 7547: brief information about the dump truck

BelAZ 7547: brief information about the dump truck

In the 1970-ies in the Soviet Union there was a question about creating a very powerful car that can help in building various large-scale energy facilities. The popularity it brought to machine, capacity above 40 tons, and the spe...

Support bearing front struts: photos, symptoms. How to replace bearing-front?

Support bearing front struts: photos, symptoms. How to replace bearing-front?

pillow block bearings are elements of the front suspension of the car. Their main task – the smoothing of the shock loads on the body. A malfunction of these items does not Bode well. In addition, the suspension and the body...

Rules for travel in a circular motion. Roundabout. New traffic rules

Rules for travel in a circular motion. Roundabout. New traffic rules

While on the road, everyone is responsible for the execution of the rules of the road regardless of the driver or pedestrian. From our integrity depend the lives of other people. Everyone knows that the slightest breach can lead t...

Protective film for car: reviews

Protective film for car: reviews

In the conditions of Russian roads is very difficult to keep cars in their original form – to wear out the body much easier. Dirt, sand, gravel flying from under the wheels – all domestic realities. To protect the car,...