What is the pressure in the engine cooling system?

Date:

2020-01-24 16:20:16

Views:

472

Rating:

1Like 0Dislike

Share:

Table of contents:

During operation of the internal combustion engine is heated to a high temperature. With the function of heat dissipation should handle the cooling system of the engine. It is necessary for the efficient operation of the power unit. If there is no circulation of coolant, then the engine will very quickly overheat with all the ensuing consequences. Let's talk about what should be pressure in the cooling system and how to troubleshoot the typical failure of their own.pressure in the cooling system of the engine

Quick facts

The First thing you need to decide what is the pressure in the cooling system. Seemingly banal coolant circulation must be sufficient for heat dissipation. Before it was when the radiator was filled with water. But it was also the norm to meet on the side of the car from under the hood which was steaming hot. This happened due to the fact that the water has time to cool, and as the temperature of its boiling point is 100 degrees, it is very fast to boil.

Modern antifreeze, a large part of which is made on the basis of alcohol, boils at about 115 degrees Celsius. But it is necessary to remember high-school physics, where you can see that the pressure increase causes the shift of the boiling point of the liquid. This also applies to antifreeze, which circulates through the engines.

What is the pressure in the engine cooling system is the norm?

A lot depends on the design features of the car. But it's usually at 1.2-1.4 bar. for passenger cars. For example, on VAZ-2110 normal rate can be considered as 1.2 atmosphere. The critical pressure in the system is achieved by heating the antifreeze and the boiling point. At this time, the pressure in the system must be reset. This is done in order to not broken the radiator or most any other weakness.

Recommended

How does the rear bushing front arm and how many it serves?

How does the rear bushing front arm and how many it serves?

The Rear bushing front arm – one of the constituent elements of the vehicle chassis. He refers to the guide elements of the suspension together with the levers endures tremendous stress with wheels. However, with this this item, there are many ...

Oil consumption in the engine. Six reasons

Oil consumption in the engine. Six reasons

It is Hardly possible to find a motorist who would not be worried about the increased oil consumption. It is especially annoying when it happens with another new motor. Here are the most common causes that result in the consumption of oil in the engi...

How does the exhaust system?

How does the exhaust system?

The exhaust System is designed to remove combustion products from the engine and output them to the environment. It also must be ensured a reduction in noise pollution to acceptable limits. Like any other complex devices, this system consists of seve...

For the pressure relief meets the surge tank cap. The device is extremely simple. There is a metal housing with two holes. Inside is a ball diameter greater than the hole. When reaching a certain temperature it rises. This leads to the fact that the air is venting to the atmosphere. On many cars 1.5 ATM. is the pressure at which it resets.

Health Check valve

While the antifreeze get warm, the bulb inside the cap closes the lower hole, while the top remains open. Need for inflow of air from the atmosphere and rapid heating of the coolant. I would like to mention that it is periodically necessary to check the efficiency of the cover. It often happens that it wedged in one of the positions. Because of this, the engine warms up or long or does not hold pressure.how much pressure in the engine cooling system

Check the surge tank cap, VAZ-2110 to perform very simple. For this it is sufficient to loosen and shake. If you can, as the ball is loose inside the case, it means the system is working and not stuck. The excess pressure in the cooling system of the engine, as noted above, can lead to fatal consequences. Therefore, on modern cars the cap has two valves: intake and exhaust. Now you can find covers that are triggered at a certain pressure. But it is highly recommended not to change the parameters laid down by the manufacturer.

High blood pressure and methods of struggle

The cooling System is designed so that the pressure in it corresponds precisely to the surge tank cap. Although there are various options of designs. For example, on some American cars the expansion tank serves as a settling tank, and the lid is installed on the tee of the radiator. However, the essence of the work remains the same.the excess pressure in the cooling system of the engine

Pressure in the cooling system of the engine VAZ-2110 must be in the range of from 1.2 to 1.5 ATM., in this fall or excess of these indicators can already be considered a serious deviation. Quite often, motorists are faced with high blood pressure. The reason is all the same cover, the valve which is stuck in the closed position. In this case, the system is warmed, the pressure increase, and reset it will not happen. It leads the vapor tube, preventing proper coolant circulation through the system.

Replace a failed node

The Cover of the cooling system can last more than a engine car, but you can buy a new one that is defective. It's hard to guess. But in any case do not try to repair it. It is worth it for most models of pennies and is non-repairable. In case of a failure, it just changed to a new one.

At the same time it is highly recommended not to shorten the springs, changing the time of activation of cover. After all, many motorists are doing this, which in most cases does not lead to anything good. Of course, if you tune the cooling system and the engine, then it is possible that we need to achieve more pressure in the system or, conversely, smaller. In other cases worth buying only original or decent analogue with the same parameters. Remember that a lot of pressure in the cooling system of the engine may lead to a local overheating of the engine and failure of certain nodes.pressurethe system of cooling of engine of vases

Leaks system

An Even more popular issue in the circle of motorists - no pressure. This can happen because of:

  • A jammed air valve;
  • Leak in the cooling system.

Accordingly, to identify the problem will not be difficult. The first thing you can look at the antifreeze level on a cold engine. If he doesn't change from trip to trip, so leaks in the system. The second item replaceable air valve for a new one. After that, the pressure should return to normal, and antifreeze will not overheat. Very often high blood pressure in the cooling system of the engine leads to the fact that it then falls. This is partly due to podklinivaet valve. It it works, then no. As a result, the pressure comes, causing a weak spot may be leaked, and after that lost tightness.

How to find a leak?

To get started is to start with a visual inspection. You should look under the car, it is likely that under him, the puddle of antifreeze. But here we need to understand that it is often a breach occurs only when a certain pressure, so the cold doesn't manage to find. However, there is a special device to discharge the pressure in the system, with the engine to avoid burns must be cold.lot of pressure in the cooling system of the engine

The device can use the normal pump and pressure gauge. All you can do in the garage environment. First detachable upper pipe, suitable to the surge tank. In the hole it is desirable to insert a bolt of suitable diameter. Further connected to the nozzle pump with pressure gauge and pump pressure. Upon reaching 1.5 ATM. should work the air valve. At the same time looking for the leak.

The Nuances of the cooling system

A Lot also depends on the coolant. Pour the water, for example, it is not necessary even in old cars, it is better to buy a cheap antifreeze, problems will be less. However, modern engines require high quality cooling. The manufacturer in the manual indicates a recommended brand of coolant. It is advisable to stick to these tips and do not dilute the antifreeze if you do not concentrate.

Modern coolants have different life time and boiling point. For example, G12 boils later than the G11, and G12++ has a high resource, but it is more expensive. In any case, in order to avoid boiling of the motor it is recommended to fill only high quality engine coolant.high blood pressure in the cooling system of the engine

Original parts

Very often the high pressure in the cooling system of the engine is formed due to a faulty air valve, that we already have. Another thing is that this valve is a scarce resource, or even a new one may be non-functional. This also applies to other elements of the cooling system like thermostat, water pump, nozzles, sensors, radiators etc. to sleep, it's better to get the original, which is often quite large. Of course, such parts are much more expensive, but they are almost 100 % guarantee the proper functioning of the node as a whole. After the failure of a seemingly insignificant item such as a lid may entail a complete engine overhaul.

As for Chinese parts, then it's a lottery. Some of them can be pretty high quality, while others do not go and 100 kilometers. Better not to risk it, because the avaricious pays twice.

Serious consequences

We already considered that the engine cooling system it creates pressure. It is quite normal. Another thing is that very often there is a condition that is extremely difficult to determine. For example, the antifreeze goes, and no visible leaks. In this case, quite possibly getting coolant into the crankcase. We recommend that you regularly check the oil level. If coolant really goes into the motor, then the level will rise. Rather, it speaks of the punched gasket cylinder head, change that is equivalent to the bulkhead of the power unit.high pressure in the cooling system of the engine

Every detail has a certain resource at which there is no guarantee that it will continue to function normally. There are cases when even a new expansion tank cap is broken. And the question now is not about the Chinese parts, and about the original. Unfortunately, it's not going anywhere.

To Summarize

So we understand, why the pressure in the cooling system of the engine, why it can be too high or, conversely, low. In self-examination often is no big deal, although much depends on the car. For example, sometimes, out of order is the temperature sensor coolant. It may give wrong data in the control devices, thereby the driver misleading. It can show how high the temperature of the power unit, and, conversely, low. But this is not to say that the system works correctly.

In case of any breakdowns in the cooling system must be eliminated as soon as possible. It is advisable not to operate the car with a jammed cap or thermostat. Because for someengines overheating is deadly, and a major overhaul is quite expensive. Overall is worth to check the level of coolant in the system to ensure that there is no leakage and other defects. It is also recommended to periodically clean the radiator from dirt, as this can cause increased engine temperature.


Article in other languages:

AR: https://tostpost.com/ar/cars/20794-what-is-the-pressure-in-the-engine-cooling-system.html

BE: https://tostpost.com/be/a-tamab-l/38412-yak-c-sk-u-s-steme-astudzhennya-ruhav-ka.html

DE: https://tostpost.com/de/autos/37998-welchen-druck-des-k-hlkreislaufs.html

ES: https://tostpost.com/es/coches/37764-la-presi-n-del-sistema-de-refrigeraci-n-del-motor.html

HI: https://tostpost.com/hi/cars/22453-what-is-the-pressure-in-the-engine-cooling-system.html

JA: https://tostpost.com/ja/cars/20429-what-is-the-pressure-in-the-engine-cooling-system.html

KK: https://tostpost.com/kk/avtomobil-der/38799-anday-ysym-zh-yes-nde-oz-alt-yshty-sal-yndatu.html

PL: https://tostpost.com/pl/samochody/40407-jakie-jest-ci-nienie-w-uk-adzie-ch-odzenia-silnika.html

PT: https://tostpost.com/pt/carros/40043-que-tipo-de-press-o-no-sistema-de-arrefecimento-do-motor.html

TR: https://tostpost.com/tr/arabalar/35274-hangi-sistem-bas-nc-motor-so-utma.html

UK: https://tostpost.com/uk/avtomob-l/39209-yakiy-tisk-v-sistem-oholodzhennya-dviguna.html

ZH: https://tostpost.com/zh/cars/20389-what-is-the-pressure-in-the-engine-cooling-system.html






Alin Trodden - author of the article, editor
"Hi, I'm Alin Trodden. I write texts, read books, and look for impressions. And I'm not bad at telling you about it. I am always happy to participate in interesting projects."

Comments (0)

This article has no comment, be the first!

Add comment

Related News

"IZH 350 Planeta Sport" – frisky Soviet bike

it is believed that of the entire line of Soviet motorcycles "IZH" truly sporty just one. It is easy to guess that it was "IZH 350 Planeta Sport".History motorcycleIn 1973 the factory "Izhmash" was made a real breakthrough: the li...

Tyres

Tyres "Michelin Alpin A4": owner reviews

Modern tires must meet a number of requirements. Quality tire provides good handling, directional stability and a number of important factors. This is especially important if we are talking about winter tires. Let's look at perfor...

"Ford Focus 1" (American, 2l, automatic): engine, technical specifications, owner reviews, photos

“Ford Focus" - a real bestseller in the Russian market. This car first appeared in 1999. Machine American production, however, focused on the world market. A lot “Tricks” now go to Europe and CIS countries. ...

Trucks ZIL 130: cars with a rich history

Trucks ZIL 130: cars with a rich history

ZIL 130 dump Trucks are the real veterans of the domestic automotive industry. These cars were off the line almost half a century in the period from 1962 to 2010. Originally the place of Assembly of these trucks were, but at the d...

The exhaust system of the car: device, principle of operation, repair

The exhaust system of the car: device, principle of operation, repair

the design of the vehicle uses a variety of systems – coolant, oil, injection system and so on. But hardly anyone pays attention to the exhaust. But it is no less important component of any car. Over the years, the design of...

Recycling program

Recycling program

died down the program of recycling of old cars, which in government circles was called the experiment on stimulation of sales of new vehicles. Since the start of this extraordinary event in March 2010, and until the end of 2011, w...